18

Merlo 18: CAN Bus Interrupted Communication

Issue description

The system has detected an interruption in communication on the CAN (Controller Area Network) bus. This indicates that one or more essential control modules, such as the engine ECU, transmission controller, joystick controller, or main safety computer, have stopped sending or receiving messages. This disruption can be caused by wiring problems, faulty components, or control module failures, and may lead to symptoms ranging from the loss of specific functions (like boom operation) to a complete machine shutdown.

Applies to these machines

  • Turbofarmer
  • Panoramic
  • Multifarmer
  • Roto
  • P40.13
  • P40.17
  • 38.7

Check the cause

  1. Visually inspect CAN bus wiring harnesses and connectors for chafed or broken wires, loose connections, or corrosion (especially around the engine, boom, and control modules)

  2. Check all relevant fuses (such as the 7.5A fuse) to ensure power is not interrupted to critical control modules

  3. Verify that all relevant ECUs are receiving the correct voltage and have a solid ground connection

  4. Isolate the faulty node by unplugging sensors and modules from the CAN bus one by one to see if communication is restored (start with exposed components like boom angle sensors or rear valve bank sensors)

  5. Measure termination resistance across CAN High and CAN Low with the machine powered off (should be approximately 60 ohms)

  6. Measure CAN bus voltage with the machine powered on (CAN High should be 2.5-3.0V, CAN Low should be 2.0-2.5V relative to ground)

  7. Use specialized tools like MerloDiag software to read live data, pinpoint which module is offline, and analyze error frames on the network

Repair steps

  1. Address basic electrical faults

    Repair any damaged wiring, replace blown fuses, or clean corroded connectors identified during the visual inspection.

  2. Replace faulty sensor or module

    If a specific sensor or module was identified as pulling down the network during the isolation check, replace that component.

  3. Replace control unit

    If diagnostics point to a faulty main control unit (ECU), replace it. Ensure the replacement part is 100% compatible by cross-referencing the machine's VIN and part number.

  4. Perform system calibration

    After replacing control units or critical sensors, perform a system calibration using diagnostic tools like MerloDiag to ensure proper function.

  5. Consult authorized dealer

    If the issue cannot be identified with basic checks, contact an authorized Merlo dealer to utilize proprietary diagnostic tools like MerloDiag to read live data and analyze error frames.

Parts you might need

(8)
  • Central Control Unit

    5125110001

    Verify compatibility with machine VIN

  • Central Board V2

    5125010002

    Verify compatibility with machine VIN

  • Hydrostatic Transmission Control Unit

    035965

    Aftermarket reference, verify with VIN

  • Aftermarket reference, verify with VIN

  • Aftermarket reference, verify with VIN

  • 7.5A Fuse

    Common cause for communication failure disabling boom and screen

  • Boom Angle Sensor

    Generic part, verify specific part number for machine model

  • Wheel Speed Sensor

    Generic part, verify specific part number for machine model

Get help to fix this fault by requesting a quote

Browse other Merlo codes