210–213

Merlo 210–213 – MERLIN / MCSS: Safety Circuit Solenoid Valve Fault

Issue description

Fault codes 210, 211, 212, and 213 indicate a fault with the safety circuit solenoid valve. The electronic control system has detected that the solenoid valve responsible for preventing machine movements (movement block) is not receiving electrical power when it should, particularly when a safety device override mode is active. This is typically caused by an interrupted signal in the valve's electrical circuit and prevents the proper operation of the machine's safety system.

Applies to these machines

  • ROTO 30
  • ROTO 38
  • ROTO 40
  • ROTO 45
  • ROTO 50
  • ROTO 60

Check the cause

  1. Check the main battery voltage and ensure terminals are secure, as low voltage can cause various electrical faults

  2. Visually inspect the wiring and connectors associated with the safety circuit and the movement block solenoid valve for damage, corrosion, or loose connections

  3. Check the solenoid valve's electrical circuit for continuity and ensure the signal is not interrupted using a multimeter

  4. Use Merlo Diagnostics to access the system's diagnostic menus and perform specific tests

Repair steps

  1. Isolate and secure the machine

    Park the machine on a level surface, lower the boom, engage the parking brake, and turn off the engine before starting any electrical work.

  2. Locate the solenoid valve

    Identify the movement block solenoid valve on the machine. Its exact location will be specified in the machine's service manual or hydraulic/electrical schematics.

  3. Test the solenoid coil

    Disconnect the electrical connector from the solenoid. Test the solenoid's coil for the correct resistance using a multimeter. An open circuit (infinite resistance) or a short circuit (zero resistance) indicates a failed solenoid.

  4. Test the circuit voltage

    With the key on and the relevant function activated (if safe to do so), test for voltage at the solenoid's electrical connector. A lack of voltage points to a problem in the wiring harness or the control module.

  5. Check circuit bypass

    Check the bypass for the circuit for testing purposes only. This should only be done by a qualified technician following official procedures to avoid disabling critical safety features.

  6. Replace faulty components

    If the solenoid is found to be faulty, replace it. If the wiring is damaged, repair or replace the affected section of the harness. If the control unit is suspected, further specialized testing is required.

Parts you might need

(3)
  • Safety Circuit Solenoid Valve / Movement Block Solenoid Valve

    Contact an authorized Merlo dealer or consult the specific parts catalog for your machine's serial number

  • Diagnostics Kit for Merlo Telehandlers

    077996

    Required for advanced system diagnostics

  • Required for advanced system diagnostics

Get help to fix this fault by requesting a quote

Browse other Merlo codes