238

Merlo 238 – Main Machine Control System / MERLIN / MCSS / ECU: Calibration Required in 'KG' Menu

Issue description

The system indicates that calibration is required in the 'KG' menu. This is a procedural instruction rather than a component fault, notifying the operator that the weight sensors (load cells) for the tip-over prevention and load monitoring system are not calibrated and require a calibration routine to function correctly.

Applies to these machines

  • Roto
  • Turbofarmer
  • Panoramic
  • Multifarmer

Check the cause

  1. Inspect the wiring harness and connectors leading to the weight sensors (load cells) for any signs of damage, corrosion, or loose connections

  2. Visually inspect the load cells for mechanical damage

  3. On outrigger-equipped models, inspect the bumper pads located between the sensor and the cylinder, as degradation can cause inaccurate readings

  4. Check for any other active fault codes, particularly CAN bus or sensor-related codes, which could interfere with the calibration process

Repair steps

  1. Access diagnostics menu

    Access the machine's diagnostics menu. This typically requires using a diagnostic key or pressing and holding the 'MENU' key on the display.

  2. Navigate to calibration

    From the main diagnostics or service menu, locate and select the calibration option. This may be indicated by a symbol.

  3. Select 'CAL Kg'

    Choose the specific calibration procedure for the weight sensors on the lift cylinder, usually labeled as 'CAL Kg' or a similar symbol.

  4. Perform calibration sequence

    Follow the on-screen instructions provided by the machine's display. Ensure the machine is on level ground with no load on the forks. You may be prompted to place a known weight on the forks and move the boom through a specific sequence of positions (e.g., fully retracted, fully extended, at certain angles).

  5. Save and exit

    Once the procedure is complete, save the new calibration values and exit the menu. The fault code should clear.

Parts you might need

(5)
  • Headstock Weigh Load Headstock Sensor

    079464

    Confirm correct part number using machine VIN or serial number before ordering

  • Outrigger Strain Gauge Load Cell

    M1476

    PGA Technika part number. Confirm correct part number using machine VIN or serial number before ordering

  • Sensor120143

    Generic sensor part. Confirm correct part number using machine VIN or serial number before ordering

  • Sensor parts

    134878

    Generic sensor parts. Confirm correct part number using machine VIN or serial number before ordering

  • Load Cell Sensor Bumper Pad

    M1802

    PGA Technika part number. Confirm correct part number using machine VIN or serial number before ordering

Get help to fix this fault by requesting a quote

Browse other Merlo codes