277

Merlo 277 – UCMS, MERlin, or CDC: Lifting Speed Faulty in Basket Mode

Issue description

This fault indicates a discrepancy between the expected and actual lifting speed when the machine's safety systems for personnel basket operation are engaged. The Adaptive Stability Control System (ASCS) restricts movement speeds for safety when a basket is attached. The fault occurs when the boom's lifting speed does not match the pre-defined safe speed for personnel basket operations, which may indicate an issue with the component responsible for controlling or enabling the lifting function.

Applies to these machines

  • ROTO
  • Panoramic

Check the cause

  1. Ensure all safety procedures are followed (park on level ground, engage parking brake, chock wheels)

  2. Verify the correct procedure for engaging basket mode is being followed (key switch turned to basket position, basket control box connected)

  3. Inspect the mechanical locking pin securing the basket to the boom carriage and ensure the safety button/switch is correctly engaged

  4. Inspect the electrical connection between the boom and the basket for damaged cables, corrosion, or loose pins

  5. Check for visible hydraulic leaks around the lift cylinder, control valves, and associated hoses

  6. Test the hydraulic pressure of the lift circuit to ensure it is within manufacturer specifications

  7. Inspect the wiring and connectors for the proportional solenoid valve controlling the lift circuit

  8. Test the solenoid valve's function to see if it is sticking or failing electronically

  9. Inspect boom angle, boom extension, and load sensors (pressure transducers) for faults that could provide incorrect speed or load data

  10. Check joystick output signals using the MerloDiag tool

  11. Perform a joystick calibration procedure if necessary

Repair steps

  1. Resolve basket recognition issues

    Ensure the basket is correctly attached and recognized by the machine. Repair or replace any faulty wiring, connectors, or mechanical pins in the recognition system. If the basket was added after purchase, pair it with the telehandler using a diagnostic tool.

  2. Address hydraulic failures

    If a faulty solenoid valve or hydraulic pressure issue is identified, replace the faulty component. This may involve replacing the specific servo control solenoid valve controlling the lift function.

  3. Replace faulty sensors

    If diagnostic testing points to a faulty boom angle, extension, or load sensor, replace the defective sensor.

  4. Recalibrate system

    After replacing components like sensors or joysticks, perform a system and joystick calibration using the Merlo diagnostic tool to ensure proper function.

  5. Consult Authorized Service

    Due to the complexity of the electronic and hydraulic systems, especially those related to safety, contact an authorized Merlo dealer or service technician for complex diagnostics and repairs.

Parts you might need

(6)
  • Also known as part number 126505

  • Alternative part numbers: 067400, 067398

  • Engine Speed & Shaft RPM Sensor

    M0555

    Aftermarket part

  • Hydraulic Control Valves/Solenoids

    Identify specific part from the machine's parts catalog

  • Boom Sensors (Angle/Extension)

    Identify specific part from the machine's parts catalog

  • Required for diagnostic software access

Get help to fix this fault by requesting a quote

Browse other Merlo codes