New Holland 10003 – Front Suspension: Lower Solenoid Error
Issue description
The Electronic Draft Control (EDC) system has detected an electrical fault related to the descent solenoid, which controls the lowering function of the three-point hitch. Specifically, current has been detected at the solenoid when it should be deactivated, pointing to a short circuit in the wiring or an internal failure within the solenoid coil itself. It can also indicate a broken electrical circuit for the solenoid valve.
Applies to these machines
60 machines- TM110
- TM115
- TM120
- TM125
- TM130
- TM135
- TM140
- TM150
- TM155
- TM165
- TM175
- TM190
- T6.120
- T6.125
- T6.140
- T6.145
- T6.150
- T6.155
- T6.160
- T6.165
- T6.175
- T6.180
- T7.235
- T8.275
- T8.300
- T8.320
- T8.330
- T8.350
- T8.360
- T8.380
- T8.390
- T8.410
- T8.420
- T8.435
- TG210
- TG215
- TG230
- TG245
- TG255
- TG275
- TG285
- TG305
- TS100A
- TS110A
- TS115A
- TS125A
- TS130A
- TS135A
- TL70
- TL80
- TL90
- TL100
- TL70A
- TL80A
- TL90A
- TL100A
- T4020
- T4030
- T4040
- T4050
Check the cause
Visually inspect the wiring harness and connectors leading to the front suspension control solenoids for chafing, breaks, or corrosion
Check fuses related to the suspension controller (e.g., 12VS1, 12VS2, 12VU2) for a blown fuse causing low voltage
Measure the resistance across the disconnected solenoid's terminals to check for an open circuit (infinite reading) or short (very low reading)
Measure voltage at the solenoid's electrical connector while the lowering function is activated to verify controller output
Test the wiring harness for continuity from the controller to the solenoid connector to rule out a broken wire
Check for continuity between the signal wire and chassis ground to identify any short circuits
Repair steps
Ensure safety
Park the tractor on a level surface, turn off the engine, remove the key, and engage the parking brake.
Locate the solenoid
Find the front suspension control valve block, typically located near the front axle assembly. Identify the 'Lower Solenoid' valve on this block.
Disconnect and test
Disconnect the electrical connector from the suspect solenoid and perform resistance and voltage tests to isolate the fault to the wiring or the solenoid itself.
Repair wiring or replace solenoid
If wiring is damaged, repair or replace the affected harness section. If the solenoid coil is open or shorted, unbolt and replace the coil, or replace the entire solenoid valve assembly if necessary.
Reassemble and test
Reconnect all connectors, start the tractor, and test the front suspension's raise and lower functions to confirm proper operation.
Clear fault codes
Use the tractor's diagnostic menu or a service tool to clear the active fault code.
Parts you might need
(19)- Solenoid Valve84273815
Confirm part number with a New Holland dealer using the machine's VIN
- Solenoid Valve84807022
Confirm part number with a New Holland dealer using the machine's VIN
- Solenoid Valve84148281
Fits many TL, TM, T4000 series
Solenoid Coil
44082Fits many TM, T6, TG, TSA, T8 series for cab suspension (may differ from axle suspension)
Fits New Holland TSA, TM, TG, T6, T8
Front Suspension / Cabin Suspension Solenoid
87652682Fits New Holland TSA, TM, TG, T6, T8
- Solenoid Valve87472229
Replaces 87723774. Fits New Holland T6.140 - T6.160, T7.220 - T7.315, T7030 - T7060, and Case IH Magnum/Maxxum
- Solenoid Valve87723774
Replaced by 87472229
- Solenoid Valve48055262
Replaces 87739558, 5196873, 84173878. Fits New Holland T6000 and T7000 series
- Solenoid Valve87739558
Replaced by 48055262
- Solenoid Valve5196873
Replaced by 48055262
- Solenoid Valve84173878
Replaced by 48055262
Complete Front Suspension Valve Kit
87364317Includes valve 47135723, solenoids 82025709 / 87652682, and accumulator 87354713. Fits T6070, TM, TSA, MXU, MXM
Front Suspension Control Valve Assembly
47135723Included in kit 87364317
- Accumulator87354713
Included in kit 87364317
Front Suspension Control Valve Assembly
47135724Front Suspension Control Valve Assembly
5197683- Solenoid47129414
Listed within '3 CCLS (EDC) ELECTRONIC CONTROL VALVES AND ASSOCIATED PARTS' diagram for T6010. Verify fitment by serial number.
Get help to fix this fault by requesting a quote