New Holland 10007 – Front Suspension Control Module: Front Suspension Will Not Lower
Issue description
The front suspension system is unable to lower, which affects the operation and functionality of the tractor. This is typically caused by a 'low side driver watchdog test failed' internal error within the control module, meaning the module cannot complete the ground circuit to command the lowering solenoid. Alternatively, it may indicate a 'Go up error' where the suspension is unable to return to its set point.
Applies to these machines
5 machines- T8 Series
- T7 Series
- T7000 Series
- TM Series
- Case Puma Series
Check the cause
Verify the active fault code using a diagnostic tool and check for related codes like 10008 (Go down error) or 10009 (Lower lockout Solenoid Error).
Inspect fuses related to the suspension control module and its power supply, as low voltage can cause internal faults.
Examine the wiring harness and connectors leading to the front suspension control valve block and the control module for corrosion, damage, or loose connections.
Check for a loss of system calibration (look for fault code 10024 'Front Suspension not calibrated').
Attempt to manually activate the 'lower' solenoid using a diagnostic tool to differentiate between a controller, wiring, or solenoid issue.
Repair steps
Depressurize hydraulic system
Safely depressurize the suspension hydraulic system following the specific procedure outlined in the service manual before working on any hydraulic components.
Diagnose control module
If all external wiring, power, and ground supplies to the controller are confirmed good, the 'low side driver' fault indicates an internal failure of the control module.
Replace control module
If determined to be faulty, replace the Front Suspension Control Module (often located within the cab or chassis).
Inspect and replace solenoids
If related codes like 10009 are present, inspect the front suspension control valve on the right-hand side of the tractor. Replace the lower solenoid if it is faulty.
Calibrate suspension system
After replacing the control module or a solenoid, calibrate the front suspension system using a diagnostic tool or through the tractor's monitor.
Parts you might need
(15)Front Suspension Control Unit
87524031Alternative part number 84296089. For New Holland T7000 and Case Puma series tractors.
ECU Front Suspension Unit
82026639For TM series tractors.
- Front Suspension Lower Solenoid84130919
For suspended axle control valve on various T7 and T8 tractors.
- Suspension Solenoid47379783
Related solenoid, consult parts diagram for specific function.
- Suspension Solenoid84128131
Related solenoid, consult parts diagram for specific function.
- Suspension Solenoid84273815
Related solenoid, consult parts diagram for specific function.
- Suspension Solenoid Valve87614490
Fits New Holland T8 series: T8.275 through T8.435
Generic New Holland valve assembly; verify fitment by VIN/Serial
- Lowering Solenoid Valve84807022
CNH Industrial. Verify correct part based on model and serial number.
Lowering Solenoid Valve
249923A1CNH Industrial. Verify correct part based on model and serial number.
- Front Suspension Position Sensor84583872
CNH Industrial
- Pressure Sensor/Transducer84409605
CNH Industrial / Danfoss. Verify correct part based on model and serial number.
- Pressure Sensor/Transducer84233818
CNH Industrial / Danfoss. Verify correct part based on model and serial number.
- Pressure Sensor/Transducer84407732
Danfoss MBS 1250 / 063G1627. Verify correct part based on model and serial number.
- Pressure Sensor/Transducer86523197
CNH Industrial / Danfoss. Verify correct part based on model and serial number.
Get help to fix this fault by requesting a quote