10017

New Holland 10017 – Front Suspension Control Module: Front Suspension Switch CAN Data Not Available

Issue description

Fault code 10017, also displayed as FSUS_ENABLE_SW_NA_ERR10017, indicates that the Front Suspension control module has detected that the front suspension enable switch is not available or is not functioning as expected. The controller is not receiving a valid signal from the switch, which prevents the operator from engaging or disengaging the front suspension system.

Applies to these machines

  • T8.275
  • T8.300
  • T8.330
  • T8.360
  • T8.390
  • T8.420
  • Magnum 235
  • Magnum 240
  • Magnum 250
  • Magnum 260
  • Magnum 280
  • Magnum 290
  • Magnum 310
  • Magnum 315
  • Magnum 340
  • Magnum 370
  • Magnum 380
  • Magnum 400

Check the cause

  1. Verify the fault code with a diagnostic tool and note any other associated codes that may indicate a broader electrical issue.

  2. Inspect the Lockout/Suspension Activation Switch in the cab for physical damage, loose connections, corrosion, and mechanical soundness.

  3. Check all fuses and relays related to the front suspension and vehicle controller circuits.

  4. Trace the wiring harness from the switch to the control module, looking for chafing, cuts, or pinch points.

  5. Disconnect and inspect connectors at both the switch and control module for bent, corroded, or pushed-out pins.

  6. Check the CAN bus network status and wiring for proper termination resistance.

Repair steps

  1. Isolate the faulty component

    Using a service manual, perform specific voltage and continuity tests on the switch and its circuit to determine if the fault lies with the switch, the wiring harness, or the control module.

  2. Repair wiring harness

    If wiring is damaged, repair the affected wires using appropriate splicing and sealing techniques. Replace the harness section if the damage is extensive.

  3. Replace activation switch

    If the switch is faulty, disconnect the negative battery terminal, remove necessary cab trim, replace the switch, and reconnect the battery.

  4. Verify repair and calibrate

    Clear the fault code using a diagnostic tool, operate the front suspension to confirm functionality, and perform a front suspension calibration if required by the service manual.

Parts you might need

(5)
  • Front Suspension Activation Switch / Lockout Switch

    Often a rocker switch located in the cab. Contact a New Holland or Case IH dealership with the tractor's model and serial number for the exact OEM part number.

  • External Control Switch Kit - Suspended Front Axle

    718045371

    Dealer Installed Accessory kit providing an external switch for raise/lower control of the front suspension

  • Individual switch included in the external control switch kit

  • Potentially related switch; direct connection to the front suspension enable function is not definitively specified.

  • Switch

    87302334

    Potentially related switch; direct connection to the front suspension enable function is not definitively specified.

Get help to fix this fault by requesting a quote

Browse other New Holland codes