1085

New Holland 1085 – EDC: Electronic Draft Control Requires Calibration

Issue description

The Electronic Draft Control (EDC) system requires calibration. The system's stored parameters for operating the three-point hitch are no longer considered valid by the control module. This affects the proper operation of the tractor's draft control functions, which are designed to automatically adjust the implement depth to maintain a consistent draft load.

Applies to these machines

  • T6.120
  • T6.140
  • T6.150
  • T6.155
  • T6.160
  • T6.165
  • T6.175
  • T6.180
  • T7.170
  • T7.185
  • T7.190
  • T7.200
  • T7.210
  • T7.220
  • T7.225
  • T7.230
  • T7.245
  • T7.250
  • T7.260
  • T7.270
  • T6020
  • T6030
  • T6050
  • T6070
  • T6080
  • T7030
  • T7040
  • T7050
  • T7060
  • TM120
  • TM130
  • TM140
  • TM155
  • TM175
  • TM190

Check the cause

  1. Use a diagnostic tool to check for and resolve any other active fault codes related to the hitch or transmission systems, as these can interfere with calibration

  2. Inspect the wiring harness and connectors for the EDC system, including draft sensors (load pins), position potentiometers, and the EDC control valve for damage, corrosion, or loose connections

  3. Ensure the three-point hitch can move through its full range of motion without any mechanical obstruction or binding

  4. Verify sensor inputs by viewing live data from the hitch position sensor and draft pins in the diagnostic menu to ensure plausible signals

  5. Check that transmission and hydraulic oil are at the correct operating temperature (above 38°C / 100°F for some models)

Repair steps

  1. Prepare the tractor

    Park the tractor on a level surface, engage the parking brake, and attach a suitable weight (approximately 200kg) to the lower linkage arms to overcome internal friction. Ensure the engine is running and hydraulic oil is at the required temperature.

  2. Enter calibration mode

    Access the diagnostic 'H' menu (e.g., by holding the 'PROG' key after turning the ignition on). Navigate to the EDC calibration setting, often designated as 'H1'. The instrument cluster display should indicate 'CAL'.

  3. Perform the calibration

    Set the engine speed to the required RPM (e.g., 1600 RPM or higher). The system will automatically move the hitch through a series of small raise and lower movements. Do not operate any other controls or leave the operator's seat during this process.

  4. Store and verify

    Once the display indicates completion, turn the tractor's ignition off to store the newly calibrated values in the control module's memory. Restart the tractor, clear the 1085 fault code, and operate the hitch to verify correct functionality.

Parts you might need

(6)
  • For TM Series models (TM120, TM130, TM140, TM155, TM175, TM190)

  • Electronic Draft Control Unit

    87397180

    For T7000 series and some TM models (Alternative: 82024844)

  • Electronic Draft Control Unit

    47130674

    For various Case IH and New Holland models

  • EDC Command Unit located in armrest

  • Supersedes 84385145, 87312146, 47128313, 5184322, 87314754. For T6, T7, T6000, T7000, and Case IH Maxxum/Puma series

Get help to fix this fault by requesting a quote

Browse other New Holland codes