New Holland 111 – ECU: EGR Potentiometer Valve Not Fully Opened
Issue description
The engine control unit has commanded the EGR valve to open, but the integrated position sensor (potentiometer) has not reported back a signal confirming the valve has reached its fully open position. This indicates a discrepancy between the commanded state and the actual physical state of the valve, which can be caused by mechanical obstruction such as carbon buildup, internal component failure, or an electrical circuit issue. This failure may negatively affect engine performance and emissions control.
Applies to these machines
11 machines- L225
- L230
- C232
- C238
- C327
- C332
- C337
- TR270B
- TR320
- TV370B
- TV380
Check the cause
Confirm the fault code is active.
Inspect the wiring harness and electrical connector at the EGR valve for damage, corrosion, or loose connections. Perform a wiggle test on the connector while monitoring sensor data.
Check for mechanical obstruction by attempting to manually move the valve mechanism (if accessible) and inspecting the valve and intake passages for heavy carbon buildup.
Use a diagnostic scan tool to monitor the EGR valve position sensor voltage or percentage while commanding the valve to open and close. Readings should change smoothly. With the connector disconnected, an ohmmeter can be used to check the resistance between the potentiometer terminals.
Perform an actuator test with a scan tool to audibly or physically verify the internal electric motor's operation.
If the valve does not move or the position is incorrect, remove the valve for bench testing and inspection.
If the valve is clean but still fails to operate correctly during electrical tests, the valve assembly has likely failed internally.
Repair steps
Prepare machine
Park the machine on a level surface and allow the engine to cool completely. Disconnect the negative battery terminal to prevent electrical hazards.
Drain coolant
If the EGR valve is coolant-fed, partially drain the cooling system below the level of the valve to prevent spills.
Disconnect components
Carefully unplug the electrical connector from the EGR valve. Disconnect any vacuum or coolant hoses, being prepared for minor fluid leakage.
Remove old valve
Loosen and remove the mounting bolts that secure the EGR valve to the engine or exhaust manifold. The valve may be stuck due to carbon buildup and may require gentle persuasion to remove.
Clean mating surfaces
Thoroughly clean all old gasket material and carbon deposits from the mounting surface on the engine to ensure a proper seal and prevent exhaust leaks.
Install new valve
Position the new gasket on the clean mounting surface. Place the new EGR valve on the gasket and hand-tighten the bolts. Use a torque wrench to tighten the bolts to the manufacturer's specified torque in a crisscross pattern.
Reconnect components
Reattach the electrical connector and any coolant or vacuum hoses that were removed.
Refill and clear codes
If the coolant was drained, refill the system to the proper level. Reconnect the negative battery cable. Use a diagnostic scan tool to clear the fault codes from the ECU.
Test operation
Start the engine and let it run for several minutes. It may be necessary to perform a relearn procedure with a scan tool so the control module can adapt to the new valve. Conduct a test run to ensure the fault code does not return.
Parts you might need
(1)- EGR Control Valve5801669153
Alternative/Superseded PN: 5801520470. Remanufactured PN: 5801669153R. Cannot be disassembled for repair and must be replaced as a unit.
Get help to fix this fault by requesting a quote