112-03

New Holland 112-03 – ECU: Offset Between Camshaft and Crankshaft - Short to B+

Issue description

The Engine Control Unit (ECU) has detected a short to B+ (battery voltage) in the circuit related to the camshaft and crankshaft position sensors. This means the signal wire has an unintended connection to a positive voltage source, disrupting the ECU's ability to accurately read the engine's rotational position and speed. Because this data is critical for controlling fuel injection and ignition timing, this electrical fault can lead to hard starting, rough running, misfires, or a complete failure to start.

Applies to these machines

  • T6
  • T7
  • T9030
  • T9040
  • T9050
  • TT60A

Check the cause

  1. Visually inspect the wiring harnesses for the camshaft and crankshaft position sensors for chafed, melted, or pinched wires that could be shorting to a power source.

  2. Disconnect the connectors for the camshaft and crankshaft sensors and the ECU to check for corrosion, bent pins, or moisture inside the connectors.

  3. Use a multimeter to test the sensor's signal wire for a short to voltage. With the sensor disconnected and the key on, the presence of battery voltage on the signal wire confirms a short to B+.

  4. If the wiring is found to be intact, inspect the sensors themselves, as a faulty sensor can cause an internal short.

Repair steps

  1. Isolate the fault

    Perform visual and multimeter diagnostic checks to determine if the short to B+ is located in the wiring harness or within one of the position sensors.

  2. Repair wiring harness

    If a short is found in the wiring harness, repair the damaged section of the wire and ensure it is properly insulated. Replace a section of the harness if the damage is severe.

  3. Replace faulty sensor

    If the wiring is confirmed to be good, the issue likely lies with either the camshaft or crankshaft position sensor. Replace the suspected faulty sensor.

  4. Clear fault code

    After repairs are complete, use a diagnostic tool to clear the fault code from the ECU.

  5. Verify repair

    Start the engine and let it run to ensure the fault code does not reappear and engine performance returns to normal.

Parts you might need

(5)
  • Replaces 2853552, 87803075. Fits T6, T7, and others.

  • Crankshaft Position Sensor

    MT40511370

    Alternative OEM part number.

  • Fits T9030, T9040, T9050 tractors.

  • OEM part number.

  • Engine Wiring Harness

    87593089

    Example part number for TT60A engine electric cable. Verify exact part for your machine.

Get help to fix this fault by requesting a quote

Browse other New Holland codes