New Holland 112 – ECM: EGR Potentiometer Valve Could Not Be Completely Closed
Issue description
The Engine Control Module (ECM) has detected that the Exhaust Gas Recirculation (EGR) valve is unable to reach its fully closed position when commanded. A valve that is stuck partially open disrupts the air-fuel mixture, which can lead to rough idling, reduced engine power, increased fuel consumption, and improper emissions control.
Applies to these machines
3 machines- T7000 series
- Workmaster series
- T8 series
Check the cause
Verify the fault code using a diagnostic tool (such as the New Holland Electronic Service Tool) to confirm that fault code 112 is active and corresponds to the EGR system.
Inspect the EGR valve and its surrounding components for any visible signs of damage, such as cracks in the housing or loose connections.
Remove the EGR valve to inspect for carbon and soot buildup, which is the most common cause of a sticking EGR valve.
Inspect the wiring harness and electrical connector to the EGR valve for any signs of corrosion, damage, or loose pins that could interrupt the signal between the valve and the ECM.
Repair steps
Disconnect the Battery
For safety, disconnect the negative battery terminal before beginning any repairs.
Locate and Remove the EGR Valve
The EGR valve is typically located on the engine's intake or exhaust manifold. Disconnect the electrical connector and any attached hoses. Remove the mounting bolts to detach the valve from the engine.
Clean the EGR Valve and Passages
If carbon buildup is present, use a suitable solvent and brush to thoroughly clean the valve and the mounting surfaces on the engine. Ensure that the valve moves freely after cleaning.
Install the New or Cleaned EGR Valve
If the valve is damaged or cannot be adequately cleaned, it should be replaced. Install the new or cleaned valve with a new gasket to ensure a proper seal. Tighten the mounting bolts to the manufacturer's specified torque.
Reconnect Components
Reattach the electrical connector and any hoses that were removed. Reconnect the negative battery terminal.
Clear Fault Codes
Use a diagnostic tool to clear the fault code from the ECM's memory.
Perform a Test Run
Start the engine and allow it to run to ensure that the fault code does not reappear and that the engine is operating smoothly.
Parts you might need
(2)- EGR Control Valve5801669153
OEM New Holland part. Alternative replacement part number is 5801520470. Verify fitment by serial number.
EGR Valve Gasket
Required for reinstalling the cleaned or new EGR valve to ensure a proper seal.
Get help to fix this fault by requesting a quote