12020

New Holland 12020: Unexpected Current Value of Electric Motor

Issue description

The system has detected an unexpected current value from an electric motor, indicating an issue with the motor's operation or its interaction with the electrical system. The control module has detected a current draw that is either higher or lower than the expected range. An unexpectedly high current can suggest a short circuit, a seized or overloaded motor, or a mechanical obstruction. An unexpectedly low current could point to a poor electrical connection, a damaged wire, an internal motor fault such as a broken winding, or a failure in the motor's driver circuit within the control module.

Check the cause

  1. Visually inspect the wiring harness and connectors associated with all electric motors for signs of damage, chafing, melting, corrosion, or loose connections

  2. Check for mechanical obstructions to ensure the component driven by the electric motor is not blocked or seized

  3. Verify battery and charging system health, as low or unstable system voltage can trigger erroneous fault codes

  4. Safely disconnect the electric motor and test its resistance across the terminals to check for open circuits or shorts

  5. Use a multimeter to measure the current draw of the motor during operation to verify if it is outside of manufacturer specifications

Repair steps

  1. Repair wiring

    If any damage to the wiring or connectors is found during inspection, repair or replace the affected components.

  2. Remove obstructions

    If a mechanical blockage is identified, clear the obstruction before re-testing the system.

  3. Replace the electric motor

    If the motor is determined to be faulty, such as having an internal short or open circuit, replace the motor assembly.

  4. Controller Issue

    If the motor and wiring are found to be in good condition, the issue may lie with the control module that monitors the motor's current. This would require further advanced diagnostics, potentially with a New Holland Electronic Service Tool (EST), to monitor live data and test the controller's outputs.

Parts you might need

(6)
  • Electric Boom Motor

    51402911

    For various sprayer models; relevance to this specific fault is unconfirmed

  • Relevance to this specific fault is unconfirmed

  • Relevance to this specific fault is unconfirmed

  • For Case IH and New Holland Round Balers; relevance to this specific fault is unconfirmed

  • Used in 31 different New Holland models; relevance to this specific fault is unconfirmed

  • CORE-ELECTRIC MOTOR

    84019727C

    Relevance to this specific fault is unconfirmed

Get help to fix this fault by requesting a quote

Browse other New Holland codes