1204

New Holland 1204 – UCM: Start Sequence - Key Switch State - Engine Running Plausibility Fault

Issue description

This fault code indicates an inconsistency in the start sequence related to the key switch state and the plausibility of the engine running. The system detects a mismatch between the expected and actual states during the start process. For example, the controller might receive a signal indicating the key is in the 'off' or 'start' position while simultaneously detecting that the engine is already running. This logical inconsistency triggers the fault code as a safety and diagnostic measure.

Applies to these machines

  • 1215
  • 1220
  • 1320
  • 1520
  • 1620
  • TT series tractors
  • skid steer models

Check the cause

  1. Verify battery health by testing the battery under load, as a weak battery can cause voltage drops leading to spurious fault codes during startup

  2. Inspect the wiring harness and connectors connected to the ignition switch, starter, and main vehicle controller (UCM) for corrosion, loose connections, or physical damage

  3. Check all fuses related to the engine control module (ECM) or ignition system

  4. Review recent events to see if the fault appeared after the machine was left in the rain or after a long period of inactivity, indicating potential moisture or battery degradation issues

Repair steps

  1. Address basic electrical issues

    Clean any corroded battery terminals, tighten loose main power and ground connections, and replace any blown fuses. Clear the fault codes and attempt to start the machine to see if the code reappears.

  2. Test the ignition switch

    Use a multimeter to check for correct voltage at the various switch positions (off, on, start). A faulty switch can send intermittent or incorrect signals to the controller (e.g., sticking in the 'start' position).

  3. Inspect starting and charging system

    If the ignition switch is functioning correctly, inspect the starting and charging systems to ensure they are not sending unexpected voltages or signals that could confuse the controller.

  4. Replace Universal Control Module (UCM)

    If all other possibilities have been exhausted and wiring is confirmed good, the UCM itself may be faulty. This should be a last resort as control modules are expensive and often require programming by a dealer.

Parts you might need

(10)
  • Ignition SwitchMT40291783

    Verify fitment by serial number.

  • Ignition Switch

    87760272

    For models like 1215, 1220, 1320. Verify fitment by serial number.

  • Ignition Switch

    641833

    For various skid steer models. Verify fitment by serial number.

  • Ignition Switch

    SBA385201900

    For models like 1320, 1520, 1620. Verify fitment by serial number.

  • For TT series tractors. Verify fitment by serial number.

  • Universal Control Module (UCM)

    84529539

    For various skid steer models, may require programming.

  • ISOBUS Electric System Control Module. May require dealer programming.

  • Universal Control Module (UCM)

    91758511

    May require dealer programming.

  • Universal Control Module (UCM)

    MT40304453

    May require dealer programming.

  • May require dealer programming.

Get help to fix this fault by requesting a quote

Browse other New Holland codes