New Holland 1223 – VCM: VCM Sustained Over Current Limit Red
Issue description
The Vehicle Control Module (VCM) is experiencing an excessive and continuous draw of electrical current. This is a critical fault (indicated by the 'Red' warning) that suggests a significant electrical issue within the affected circuit or component, which could lead to module failure.
Applies to these machines
16 machines- L213
- L215
- L218
- L220
- L221
- L223
- L225
- L228
- L230
- L234
- C227
- C232
- C234
- C237
- C238
- C245
Check the cause
Use an Electronic Service Tool (EST) to confirm that fault code 1223 is active.
Determine if the fault is active or intermittent. A persistent active fault strongly suggests an internal VCM failure, while an intermittent fault points to an external electrical issue.
Check the battery and its connections. Ensure all power and ground connections to the VCM are clean and secure, as low voltage or poor connections can cause electrical faults.
Thoroughly inspect the wiring harnesses and connectors related to the VCM for frayed wires, cracked insulation, corrosion, or water intrusion.
Repair steps
Confirm diagnosis
If the fault is active and all external wiring and power supplies have been inspected and found to be in good condition, the VCM is likely faulty.
Replace the VCM
Replace the Vehicle Control Module (VCM/UCM). Note that some service bulletins indicate this may also require replacing the mounting bracket and main harness in certain cases.
Calibrate and program
After replacing the VCM, perform a calibration or programming procedure using the New Holland Electronic Service Tool.
Parts you might need
(3)- Vehicle Control Module (VCM)47395504
Replaces 84267444. Fits various L-Series and C-Series loaders. Available as a remanufactured unit.
- Vehicle Control Module (VCM)84348127
Fits specific L-Series and C-Series loaders.
Actia OEM part for New Holland equipment.
Get help to fix this fault by requesting a quote