13001

New Holland 13001 – Display Unit: Display Does Not Detect Datacard

Issue description

The primary display monitor is unable to detect the inserted datacard (USB flash drive). This prevents the transfer of data such as yield maps, coverage data, field boundaries, or prescription files. The fault is triggered when the display's software attempts to access the USB port and finds no responsive device, which can be caused by a faulty USB drive, physical damage to the display's USB port, or an internal software issue.

Applies to these machines

  • T6 Series
  • T7 Series
  • T8 Series
  • T9 Series
  • CR Series Combine
  • CX Series Combine
  • Guardian Series Sprayer

Check the cause

  1. Verify the USB flash drive is fully and correctly inserted into the display's USB port

  2. Test with a different, known-good USB flash drive to rule out a faulty datacard

  3. Examine the original USB drive for any physical damage to its connector

  4. Attempt to reformat the USB drive using the FAT32 file system on a computer (Note: this will erase all data on the drive)

  5. Carefully inspect the USB port on the IntelliView display for physical damage, debris, or corrosion

  6. Power cycle the display system off and on again after inserting the datacard to activate data logging

Repair steps

  1. Replace USB drive

    If the original USB drive is faulty or unrecognized, replace it with a new, high-quality USB flash drive (OEM or reputable aftermarket). Format the new drive to FAT32 before use.

  2. Clean USB port

    If the display's USB port is dirty, power off the unit and use compressed air to gently blow out debris. Use a specialized electronic contact cleaner if corrosion is present.

  3. Update display software

    Ensure the IntelliView display is running the latest software version, as software bugs can prevent USB device recognition. Contact a dealer for updates.

  4. Repair USB port

    If the USB port is physically damaged (e.g., bent pins), send the display unit to a specialized third-party electronic repair service center for port replacement.

  5. Replace display unit

    If the USB port is not repairable or the display has an internal hardware failure, replace the entire display unit.

Parts you might need

(4)
  • OEM CNH Industrial part. Must be formatted to FAT32.

  • OEM CNH Industrial part. Must be formatted to FAT32.

  • Replacement for the entire display unit (also fits Case IH AFS 700). Verify exact part number for specific machine.

  • USB Port Assembly

    No OEM part number available; repair typically handled by specialized electronic service centers.

Get help to fix this fault by requesting a quote

Browse other New Holland codes