New Holland 13021 – INST: Transmission Oil Temp Sensor Voltage Low
Issue description
This fault code indicates one of two primary conditions depending on the tractor series. Generally, it signifies that the voltage from the transmission oil temperature sensor is below the expected range, suggesting a short to ground. However, on specific models like the T7 series, it indicates 'Supply voltage 12VS2 - voltage too low', pointing to a low voltage issue in a specific power supply circuit or the EDC control unit.
Applies to these machines
20 machines- T8.xxx
- TG215
- TG245
- TG275
- T6.120
- T6.180
- T7.165
- T7.270
- T6020
- T6090
- T7030
- T7060
- TM115
- TM190
- TL Series
- TSA Series
- T8040
- T8050
- T8.275
- T8.435
Check the cause
Visually inspect the wiring harness leading to the transmission oil temperature sensor for chafing, cuts, or melted insulation.
Check the sensor connector to ensure it is clean, secure, and free of corrosion.
Disconnect the sensor and check for a 5V reference voltage at the harness-side connector with the key in the 'on' position.
With the key off and sensor unplugged, check for continuity between the signal wire in the harness and chassis ground to verify if there is a short to ground (should be an open circuit).
Test the sensor's resistance using a multimeter; as a thermistor, its resistance should decrease smoothly as the temperature increases (can be tested by warming the sensor or placing it in water with a thermometer). A sudden drop to very low resistance or an open circuit indicates a faulty sensor.
Repair steps
Ensure safety and prep machine
Park the tractor on a level surface, turn off the engine, engage the parking brake, and allow the transmission to cool to prevent burns from hot fluid.
Locate and disconnect sensor
Find the transmission oil temperature sensor on the transmission housing. Place a drain pan underneath to catch any oil, then disconnect the electrical connector.
Perform Diagnostic Tests
Carry out the diagnostic checks listed above to confirm whether the fault is with the sensor, the wiring, or the controller.
Repair wiring harness
If a short to ground was found during diagnostics, locate the damaged section of the harness and repair it using sealed connectors and heat shrink to protect against moisture and vibration.
Replace faulty sensor
If the sensor failed the resistance test, unscrew it from the housing. Lightly lubricate the O-ring on the new sensor with clean transmission fluid, thread it in, and tighten to the manufacturer's specified torque. Do not overtighten.
Reconnect and verify
Securely reconnect the electrical connector, clear fault codes using the tractor's diagnostic menu, and run the tractor to operating temperature to check for leaks and ensure the code does not return.
Parts you might need
(10)General New Holland Agriculture applications
- Transmission Sensor87548200
OEM for T8 and TG Series (TG215, TG245, TG275, T8040, T8050)
Supersedes 84152541, 47447472, 84486550. Fits T6, T7, T6000, T7000, TM, Puma, Maxxum
OEM for CVT transmissions (Auto Command, Magnum, Maxxum, Puma)
- Transmission Sensor84574743
Fits T8 Series (T8.275 - T8.435) and Case IH Magnum
Transmission Temperature Sender Switch
Generic replacement part name
Common on many New Holland and Case IH models.
Common on many New Holland and Case IH models.
Specifically noted for newer T9 series tractors (e.g., T9.645, T9.700).
Get help to fix this fault by requesting a quote