New Holland 13021 – Instrument Cluster: 12VS2 Circuit Voltage Too Low
Issue description
The voltage in the 12VS2 circuit is below the acceptable level, which may affect the operation of the connected component. Primarily, this indicates that the dedicated 12-volt power supply circuit for the instrument cluster is reading below its required operational voltage, potentially affecting gauges, warning lights, and digital displays. On some specific models or configurations, this same code may alternatively indicate that the transmission oil temperature sensor voltage is too low (short to ground).
Applies to these machines
13 machines- T7.170
- T7.185
- T7.200
- T7.210
- T7.220
- T7.235
- T7.250
- T7.260
- T7.270
- T7030
- T7040
- T7050
- T7060
Check the cause
Check battery and charging system health (a weak battery reading below 12.6V at rest or a malfunctioning alternator can trigger ghost low-voltage codes). Start the tractor and check if the system voltage increases, indicating a functioning alternator.
Inspect main power and ground connections, including the main ground strap from the battery to the chassis, primary battery terminals, chassis grounds, and main power connections to the cab.
Verify if other fault codes are present across different modules (e.g., Engine, Transmission), which would indicate a systemic power supply or grounding problem rather than an isolated cluster fault.
Inspect the wiring harness leading to the instrument cluster for chafing, corrosion, or rodent damage, especially at connectors, firewall pass-throughs, and frame securing points.
Repair steps
Confirm the fault
Clear the fault code and operate the tractor to see if the code returns. If it does, proceed with circuit testing.
Locate the 12VS2 circuit
Consult the service manual or wiring diagram for your specific tractor model to identify the exact wire and pin for the 12VS2 power supply at the rear of the instrument cluster connector.
Test voltage at the cluster
With the key on, back-probe the 12VS2 pin at the instrument cluster connector and measure voltage to a known good ground. If voltage is below 12V, the problem is upstream (power supply). If normal, the issue is likely internal to the cluster.
Check fuses and relays
If voltage is low at the cluster, identify and test the fuses that supply power to the instrument cluster. Test for voltage on both sides of the fuses.
Isolate the faulty component
If all wiring, fuses, and connections to the instrument cluster test good and the voltage at the connector is normal, the fault is likely internal to the instrument cluster. In this case, the cluster itself would require replacement.
Parts you might need
(5)Verify fitment by serial number
Verify fitment by serial number
Instrument Cluster (5000, 6000, 7000 series)
51585491Verify fitment by serial number
Instrument Cluster
SBA385040950Fits various models including some T7 tractors. Verify fitment by serial number
- Instrument Cluster84587381
Superseded part number. Verify fitment by serial number
Get help to fix this fault by requesting a quote