13022

New Holland 13022 – Instrument Cluster or Universal Control Module (UCM): 12VT1 Power Supply Voltage - Too Low Voltage

Issue description

The power supply voltage for the 12VT1 component is below the required level, indicating a low voltage condition on the 12VT1 power supply rail. This circuit is associated with the Two Speed Input Power, which may affect the proper operation of transmission or PTO functions that utilize multiple speed settings.

Applies to these machines

  • T7.210
  • T7.220
  • T7.235
  • T7.250
  • T7.260
  • T7.270

Check the cause

  1. Test battery voltage to ensure it is at a full charge of approximately 12.6V

  2. Check alternator output with the engine running (should be stable between 13.8 and 14.4 volts)

  3. Inspect all main ground straps, particularly from the battery box to the chassis, for cleanliness and tightness

  4. Inspect fuses and relays, including the 5-amp instrument cluster fuse, transmission controller fuse, general ECU power fuses, and main power distribution fuses

  5. Perform a voltage drop test on both the positive and negative sides of the electrical circuit

  6. Inspect the wiring harness and connectors to the instrument cluster and control modules for corrosion, chafing, or damage

Repair steps

  1. Address basic electrical issues

    If low battery voltage, poor ground connections, or a faulty alternator are identified, charge or replace the battery, clean and tighten grounds, or replace the alternator.

  2. Replace blown fuses

    Replace any blown fuses with a new one of the same amperage rating. If the fuse blows again, locate and repair the short circuit in the wiring or faulty component.

  3. Repair wiring and connectors

    Clean corroded connectors with electrical contact cleaner, or repair/replace damaged sections of the wiring harness.

  4. Replace control module

    If all other possibilities have been exhausted and the fault persists, replace the specific control module, such as the instrument cluster.

Parts you might need

(6)
  • Mini Fuse - 5 Amp

    For instrument cluster on some models

  • Mini Fuse - 20 Amp

    10401190
  • Power supply to maxi fuse block

  • Micro Relay, 12V, 20A

    84157157
  • Instrument Cluster

    84244849

    For T7.235 models; replaces to other numbers depending on configuration

Get help to fix this fault by requesting a quote

Browse other New Holland codes