New Holland 14005 – ICU: PTO Shaft Speed Data Error or Not Available
Issue description
The Instrument Control Unit (ICU) has detected an error or a complete loss of the Power Take-Off (PTO) shaft speed signal. The ICU expects to receive valid speed data from the PTO controller, and when this data is implausible, erroneous, or entirely absent, the fault code is triggered. This indicates a breakdown in the communication of critical operational data from the PTO system to the tractor's main control interface, which is relied upon for displaying PTO speed and managing automated safety processes.
Applies to these machines
8 machines- T4
- T5
- T6
- T7
- T8
- TG Series
- T8000 Series
- Workmaster Series
Check the cause
Verify that fault code 14005 is active and persistent by clearing codes and operating the machine to see if it returns
Inspect the wiring harness and connectors leading to the PTO speed sensor for chafing, abrasion, corrosion, or improper routing. Ensure connections are secure and clean at both the sensor and the main vehicle loom
Check safety interlocks and switches related to the operator's seat, clutch, and PTO engagement switch for faults that could contribute to PTO system errors
Assess battery and system voltage to ensure the charging system maintains a stable 13.8-14.2V when running, as low voltage can cause ghost communication codes
Repair steps
Locate PTO speed sensor
Find the PTO speed sensor on the rear of the tractor, mounted on the rear axle or transmission housing near the PTO output shaft. Remove any protective covers if necessary.
Test PTO speed sensor
Disconnect the sensor's electrical connector. Using a multimeter set to measure resistance (Ohms), measure across the sensor's pins. An open circuit (infinite resistance) or a dead short (near-zero resistance) indicates a failed inductive magnetic pickup sensor.
Replace PTO speed sensor
If faulty, remove the retaining bolts and replace the sensor. Have rags ready for potential oil leaks. Ensure any required air gap between the sensor tip and the tone wheel is set correctly, and clean the connector thoroughly before plugging it in.
Clear codes and test
Reconnect the battery if disconnected, clear the 14005 fault code from the ICU memory using a diagnostic tool, and operate the PTO at various speeds to confirm the repair.
Parts you might need
(16)- PTO Speed Sensor47767004
Verify exact fitment by serial number.
- PTO Speed Sensor84165809
Replaces 47767004. Verify exact fitment by serial number.
PTO Speed Sensor
82022718Verify exact fitment by serial number.
PTO Speed Sensor
82030541Verify exact fitment by serial number.
- PTO Speed Sensor87564763
Verify exact fitment by serial number.
- PTO Speed Sensor84574743
Verify exact fitment by serial number.
- PTO Speed Sensor5150991
Verify exact fitment by serial number.
PTO Control Module
82011707Less common cause of this fault code. Verify module failure before replacing.
- PTO Speed Sensor (3-Pin)84541361
Ensure you are purchasing an automotive-grade sealed sensor.
- PTO Speed Sensor (3-Pin)87586073
Ensure you are purchasing an automotive-grade sealed sensor.
PTO Speed Sensor (3-Pin)
84408198Cross-references to Case/New Holland and ZF part 0501.337.896. Ensure you are purchasing an automotive-grade sealed sensor.
PTO Speed Sensor
84373571Superseded by 47767004.
- PTO Speed Sensor84555913
Superseded by 47767004.
- Rear PTO Shaft Speed Sensor47767008
For T5, T6, T7, T6000, and Case IH models.
- Speed Position Sensor87803075
For T4 and T5000 series tractors.
- Speed Position Sensor504049164
For T4 and T5000 series tractors. Alternate part number to 87803075.
Get help to fix this fault by requesting a quote