14019

New Holland 14019 – Main Instrumentation Controller or Body Controller: Automatic Temperature Control System Disconnected from Network

Issue description

The main vehicle controllers are not receiving a communication signal from the Automatic Temperature Control (ATC) module over the Controller Area Network (CAN bus). This loss of network connection prevents the proper operation of the cab's heating and air conditioning system.

Applies to these machines

  • TG255
  • TG285
  • T8040

Check the cause

  1. Visually inspect the wiring harness and connectors leading to the ATC module for chafing, corrosion, pinched wires, or loose connections

  2. Check for a 12-volt power supply and a solid ground connection at the ATC module and A/C control relay

  3. Perform a CAN bus termination resistor check with power OFF (should read approximately 60 Ohms between CAN_H and CAN_L)

  4. Perform a CAN bus voltage check with power ON but inactive (CAN_H to ground should be 2.5V-3.0V; CAN_L to ground should be 2.5V-2.0V)

  5. With the ATC module unplugged, measure resistance to ground on the module's CAN_H and CAN_L pins (should be in the mega-ohm range; low resistance indicates a damaged transceiver)

Repair steps

  1. Confirm fault codes

    Use the New Holland Electronic Service Tool (EST) or a compatible diagnostic tool to confirm active fault code 14019 and check for any other related network codes.

  2. Locate ATC module

    Locate the ATC module on the machine. A common location is under the operator's seat, which may require removing a panel at the base of the seat.

  3. Inspect and clean connectors

    Disconnect the electrical connector from the ATC module. Inspect the pins and sockets for corrosion, damage, or a loose fit. Clean or repair as necessary, and trace the harness for visible damage.

  4. Repair CAN bus wiring

    If the CAN bus electrical tests (resistance or voltage) yielded incorrect readings, inspect the entire CAN harness to locate and repair the fault, such as a missing or extra terminator, or a short/open circuit in the wiring.

  5. Isolate the ATC module

    If the CAN bus wiring and termination appear correct, disconnect the ATC module to see if other network communication on the machine stabilizes. This helps confirm if the module itself is pulling the network down.

  6. Replace ATC module

    If all diagnostic steps point to a faulty module and the wiring is intact, replace the Automatic Temperature Control module.

Parts you might need

(3)
  • Common part for a wide variety of New Holland equipment. Verify fitment by serial number.

  • Alternate ATC module part number. Verify fitment by serial number.

  • Automatic Temperature Control Module

    411438A1C

    Specified in diagrams for the TG255 tractor (marked as Medallion MDC-1600).

Get help to fix this fault by requesting a quote

Browse other New Holland codes