New Holland 14042 – MIU: Engine Coolant Temperature Sensor Short To Ground
Issue description
The Master Implement Unit (MIU) has detected a short circuit to ground in the Engine Coolant Temperature (ECT) sensor's electrical circuit. This condition leads to inaccurate engine coolant temperature readings, which can negatively impact engine performance and trigger warning indicators.
Applies to these machines
17 machines- T5040
- T5050
- T5060
- T5070
- TM120
- TM130
- TM140
- TM155
- TM175
- TM190
- T5 Series
- T6 Series
- T7 Series
- T8 Series
- T9 Series
- TC18
- TC21
Check the cause
Visually inspect the wiring harness and connector for the engine coolant temperature sensor for frayed wires, corrosion in the connector pins, or a loose connection.
Check for a 5-volt reference signal from the Engine Control Unit (ECU) at the disconnected sensor connector with the ignition on (engine off).
Check for ground continuity between the sensor's harness connector ground wire and a known good chassis or engine block ground with the ignition off.
Perform a sensor resistance test by removing the sensor and measuring resistance across its pins in both ice-cold and boiling water to verify that resistance changes with temperature.
Repair steps
Safety First
Ensure the engine is completely cool and relieve any pressure from the cooling system before proceeding.
Locate the Sensor
The Engine Coolant Temperature sensor is typically located near the thermostat housing in the cylinder head or on a coolant passage on the engine block.
Disconnect and Remove
Disconnect the electrical connector from the sensor. Using an appropriate wrench, carefully unscrew and remove the old sensor from the engine.
Install the New Sensor
Thread the new sensor into the engine's coolant passage and tighten it to the manufacturer's specified torque. Do not overtighten.
Reconnect
Securely attach the electrical connector to the new sensor.
Refill Coolant
Top off the engine coolant to the proper level to replace any that was lost during the sensor replacement.
Clear Fault Codes
Use a diagnostic tool to clear the 14042 fault code from the control module's memory.
Verify the Repair
Start the engine and let it run, monitoring the engine temperature gauge to ensure it is providing a plausible reading. Check for any leaks around the new sensor.
Parts you might need
(7)OEM part. Alternate OEM: B67043. Aftermarket cross-references: 82017881, 500382599
Engine Coolant Temperature Sensor (Various Ag Models)
85802504OEM part
Engine Coolant Temperature Sensor (T5/T6/T7 Series)
QTP-44446Aftermarket part
OEM part. Alternate OEM: SBA385720010, 87761510
OEM part
Other potential part number
Engine Coolant Temperature Sensor
MT40283508Replaced by SBA385720530
Get help to fix this fault by requesting a quote