14051

New Holland 14051 – Instrument Cluster: Fuel Level Sensor Shorted or Open

Issue description

The instrument cluster has detected an electrical fault in the fuel level sensing circuit. The voltage reading from the fuel level sensor is outside its normal operating range, indicating either a short circuit to a power source (Vcc) or a complete break (open circuit) in the wiring. This prevents the instrument cluster from receiving a valid signal, resulting in a non-functional fuel gauge and incorrect fuel level readings.

Applies to these machines

  • T7 Series
  • T8 Series
  • TG Series
  • TG230
  • L200 Series
  • 8870
  • TL Series
  • Case JXU
  • T6070
  • T6090
  • T7230

Check the cause

  1. Visually inspect the wiring harness and connectors leading to the fuel tank and fuel level sensor for chafed, pinched, or corroded wires.

  2. Check the ground connections for the fuel gauge system to ensure they are clean, tight, and free of corrosion.

  3. Check power supply to the sensor: disconnect the sensor connector, turn ignition ON, and measure voltage between the power supply pin and chassis ground (expecting approximately 8 VDC).

  4. Check sensor ground: with ignition OFF, measure resistance between the sensor ground pin and chassis ground (should be less than 1 Ohm).

  5. Check the signal wire for continuity between the sensor connector and the instrument cluster, and ensure there is no short to power or ground.

  6. Test the fuel level sensor resistance by measuring across the signal and ground pins while manually moving the float arm; resistance should change smoothly without infinite/open readings.

Repair steps

  1. Prepare machine for service

    Disconnect the negative battery terminal. Ensure the fuel level is low to minimize spillage and work in a well-ventilated area away from ignition sources.

  2. Access the fuel level sensor

    Locate the sensor on top of the fuel tank. This may require removing a cover plate or panel (e.g., under a central cover on the hood).

  3. Perform Diagnostics

    Complete the diagnostic checks to confirm whether the fault lies with the wiring or the sensor itself.

  4. Repair wiring harness

    If diagnostic checks revealed an open circuit, short, or bad ground, repair or replace the damaged section of the harness. Ensure connections are clean and apply dielectric grease to prevent future corrosion.

  5. Replace fuel level sensor

    If the sensor failed the resistance test, disconnect the wiring harness, remove the retaining screws or ring, and lift the old sensor out. Install the new sensor using a new gasket to ensure a proper seal and prevent fuel leaks.

  6. Verify repair

    Reconnect the battery, turn the ignition on, and verify the fuel gauge provides a plausible reading. Clear the fault code using a diagnostic tool or operator's manual procedure, then check for leaks after refueling.

Parts you might need

(7)
  • For T8 series, T6070, T6090, T7230

  • For New Holland 8870

  • For TL Series and Case JXU

  • For T6090, T6070, T7230

  • Verify fitment by serial number

  • Fuel Level Sensor

    9860032

    Commonly for skid steer loaders

  • Fuel Level Sensor

    89860032

    Aftermarket replacement, commonly for skid steer loaders

Get help to fix this fault by requesting a quote

Browse other New Holland codes