14081

New Holland 14081 – ECM or EDC: Engine Oil Pressure Short to 12 or 5 Volts

Issue description

This is an electrical fault indicating that the signal circuit for the engine oil pressure sensor is experiencing a short to a high-voltage source (either the 5-volt reference line or the 12-volt battery power). Because of this short circuit, the sensor sends an out-of-range high voltage signal to the computer, preventing the system from accurately reading the engine's oil pressure.

Applies to these machines

  • T5
  • T6
  • T7
  • T8
  • T9
  • T7.210
  • T7.270
  • T6070
  • T6020
  • T6030
  • T6050
  • T6080
  • T7030
  • T7040
  • T7050
  • T7060
  • TS90
  • TS100
  • TS115A
  • TS125A
  • TS135A
  • CX8070
  • CR9060
  • LS180
  • LS190
  • LX865
  • LX985

Check the cause

  1. Verify actual oil pressure using a mechanical gauge to rule out a critical mechanical lubrication issue

  2. Inspect the wiring harness and connectors leading to the engine oil pressure sensor for chafing, melting, corrosion, or a loose fit

  3. Check the sensor's electrical connector for oil contamination, which indicates an internal diaphragm failure

Repair steps

  1. Prepare machine for service

    Park on a level surface, lower attachments, engage parking brake, and disconnect the negative battery cable.

  2. Locate the sensor

    Find the engine oil pressure sensor on the side of the engine block near the oil filter housing, or at the rear of the engine on some FPT models.

  3. Test wiring for short to power

    With the sensor unplugged and ignition ON (engine off), measure voltage between the signal wire terminal and chassis ground. A reading of 5V or 12V confirms a harness short.

  4. Test the sensor

    If the wiring harness tests clear, test the sensor by checking its resistance with a multimeter, comparing against specific resistance values from a service manual.

  5. Repair wiring harness

    If a short is found in the harness, repair the damaged section using appropriate splicing and sealing techniques to protect it from moisture and vibration.

  6. Replace oil pressure sensor

    If the wiring tests clear and the sensor is determined to be faulty, unscrew the old sensor, apply sealant to the new sensor's threads (if specified), install to specified torque, and reconnect the harness.

  7. Verify repair

    Reconnect the battery, start the engine, check for leaks, and monitor the instrument panel to ensure the fault code clears and pressure is normal.

Parts you might need

(9)
  • Common for FPT/NEF engines in T5, T6, T7 series. May supersede 84385193, 87312194, 47128361, 5801474161.

  • Listed for various tractors and skid steer loaders.

  • Engine Oil Pressure Sensor

    9847720

    Fits skid steer models like LS180 and LS190.

  • Used on some compact tractor models.

  • Common for T6, T7, T8, T9 tractors and CR/CX combines

  • Common for TM, TS, and older G/M series tractors; 1/4 NPT thread, spade terminal

  • Engine Oil Pressure Sensor / Switch

    5166458

    Common for TN and TD series compact/utility tractors; M12x1.5 thread

  • Engine Oil Pressure Sensor / Switch

    87548759

    Common for TN and TD series compact/utility tractors; M12x1.5 thread

  • Alternative switch for specific Ford/New Holland engines

Get help to fix this fault by requesting a quote

Browse other New Holland codes