New Holland 14100 – ADIC: Pneumatic Brake Sensor Not Configured

The electronic control system has detected a signal from a pneumatic brake pressure sensor, but the pneumatic brake system option has not been enabled or configured within the instrument cluster controller. This software configuration mismatch prevents the system from properly utilizing the sensor's input or recognizing it correctly. This condition typically occurs when a new, unconfigured controller is installed on the tractor or if a pneumatic brake system is retrofitted.

• T5.95
• T5.105
• T5.115
• T5040
• T5050
• T5060
• T5070
• T6
• T7
• T8
• TG

1. 1

   Confirm tractor configuration to verify if the machine is genuinely equipped with a pneumatic trailer brake system (incorrect software may be searching for a non-existent sensor)

2. 2

   Check for recent repairs or software updates that may have incorrectly altered the system configuration

3. 3

   If the pneumatic brake system is physically present, inspect the pneumatic brake pressure sensor, wiring harness, and connectors for visible damage

4. 4

   Verify system power to ensure electronic modules are receiving the correct voltage, as low voltage can trigger configuration-related errors

1. 1

   Connect service tool

   Have a qualified technician connect the New Holland Electronic Service Tool (EST) to the tractor's diagnostic port.

2. 2

   Access ADIC configuration

   Using the EST, navigate to the configuration settings for the Advanced Dashboard Instrument Cluster (ADIC).

3. 3

   Configure pneumatic brake sensor

   Locate the settings for the pneumatic trailer brake system. If the tractor has pneumatic brakes, enable and calibrate the pneumatic brake pressure sensor to register it with the control module. If the tractor does not have pneumatic brakes, disable the pneumatic brake system option so the ADIC stops looking for the sensor.

4. 4

   Clear fault codes

   After the configuration is correctly set in the ADIC, clear all active and stored fault codes.

5. 5

   Cycle power and test

   Turn the tractor off and then on again. Operate the tractor and the brake system (if equipped) to ensure the fault code does not reappear.