15013

New Holland 15013 – Steering Controller (KA): Change Valve Or Split Valve Spools - Stuck Closed

Issue description

The fault indicates that a Change Valve or Split Valve spool within the advanced steering system is stuck in a closed position. This prevents the CustomSteer™ or Fast Steer system from functioning as intended, disabling the variable steering ratio. The Steering Controller (KA) logs this code when the valve fails to move to an open or commanded state during periodic position checks.

Applies to these machines

  • T6 Dynamic Command
  • T6 Auto Command
  • T7 AutoCommand
  • T7 Power Command
  • T7 Range Command
  • T8 Genesis
  • T7030
  • T7040
  • T7050
  • T7060

Check the cause

  1. Check hydraulic fluid level and inspect for contamination (cloudy appearance, metal particles, or burnt smell). If contamination is found, replace the fluid and hydraulic filter. Check for any other active hydraulic system fault codes.

  2. Ensure the tractor is at operating temperature, as cold oil (below 5°C) can cause sluggish valve movement and disable the fast steer system.

  3. Visually inspect the wiring harness and connectors leading to the steering control valve assembly and Change Valve Solenoid for damage, corrosion, or loose connections.

  4. Test the Change Valve Solenoid for proper resistance using a multimeter (zero ohms indicates a short, infinite indicates an open circuit) and perform a click test with battery voltage.

  5. Check for active steering system calibration faults (such as 15024) that might require a recalibration procedure.

Repair steps

  1. Access and clean valve

    Locate the steering control valve assembly, which is often coupled to the steering motor (orbitrol). Thoroughly clean the exterior to prevent contamination during disassembly.

  2. Remove valve cartridge

    Carefully remove the Change Valve Solenoid and the valve cartridge it controls. Note the orientation of all parts, seals, and washers.

  3. Inspect and clean spool

    Inspect the valve spool and bore for scoring, burrs, or contamination. Clean with a suitable solvent and lint-free cloth, ensuring the spool moves freely without binding.

  4. Replace valve components

    If the spool is damaged or continues to bind after cleaning, replace the specific cartridge or the entire valve assembly.

  5. Reassemble and test

    Reinstall components with correct seal seating and torque to manufacturer specifications. Reconnect electricals, warm up the tractor, clear codes, and operate steering lock-to-lock multiple times, engaging the CustomSteer/Fast Steer function if applicable, to verify the repair. Perform a system calibration if required.

Parts you might need

(11)
  • For T6 and T7 series tractors

  • For T7.200 AutoCommand tractors

  • Steering Valve

    47403446

    For T7 and T7000 series

  • Steering Valve

    47395762

    For T7 and T7000 series

  • For T7 and T7000 series

  • Steering Change Valve Solenoid

    Generic part name, often integrated into the larger steering valve assembly

  • Steering Control Valve

    Generic part name

  • Hydrostatic Steering Orbitrol Unit

    Generic part name

  • Example part number for T7.200. Individual solenoid that actuates a valve spool. Verify fitment by serial number.

  • Example part number for T7.200. Internal sliding component housed within the main valve block. Verify fitment by serial number.

  • Fast Steering Valve / Hydraulic Manifold

    84166211

    Example part number for T7.250 (replaces 87550052). Complete valve block assembly. Often recommended if individual spools are damaged or seized.

Get help to fix this fault by requesting a quote

Browse other New Holland codes