151

New Holland 151 – TRANS: Front Suspension Pressure Sensor Rod Side Open Circuit

Issue description

The transmission control module has detected a loss of electrical continuity (an open circuit) in the front suspension pressure sensor on the rod side. This indicates that the signal from the sensor is not reaching the controller, preventing the system from properly monitoring and controlling the hydraulic pressure on the rod side of the front suspension cylinder. This condition can lead to improper suspension performance, potentially causing the suspension to feel locked or unresponsive.

Applies to these machines

  • T7 Series
  • T7.190
  • T7.235
  • T7.270
  • T8 Series
  • T8.275
  • T8.360
  • T9 Series
  • TG Series
  • TJ Series

Check the cause

  1. Visually inspect the wiring harness leading to the front suspension pressure sensor for chafing, rubbing, pinching, or corrosion, especially where it routes over the radiator or near moving suspension components

  2. Check the electrical connectors at the sensor and at the transmission controller for dirt, debris, moisture, or corrosion, and ensure they are securely seated

  3. Perform a continuity test on the signal wire between the sensor connector and the controller connector (an infinite resistance reading indicates a broken wire)

  4. With the key on, check for the correct voltage supply and a good ground at the sensor's electrical connector

  5. If wiring and voltages are correct, test the sensor by substituting it with a known good unit

  6. Check if front suspension calibration issues are triggering related fault codes

Repair steps

  1. Prepare machine safely

    Park the tractor on a level surface, engage the parking brake, turn off the engine, and relieve any residual hydraulic pressure in the system according to manufacturer guidelines.

  2. Locate the sensor

    Locate the rod-side pressure sensor on the hydraulic circuit connected to the rod end of the front suspension cylinder, typically found on or near the suspension control valve block.

  3. Repair wiring or connectors

    If diagnostic checks revealed an open circuit in the harness, repair or replace the damaged wiring section and clean any corroded connectors. Ensure repaired wires are protected from future chafing.

  4. Replace the pressure sensor

    If the wiring is intact, disconnect the electrical connector and unscrew the old sensor (be prepared for residual hydraulic fluid to leak). Install the new pressure sensor, tighten to the correct torque specification, and reconnect the harness.

  5. Clear fault codes

    Use the tractor's onboard diagnostics or a New Holland diagnostic tool to clear fault code 151 from the TRANS controller.

  6. Perform calibration

    If required for your model, perform the front suspension calibration procedure to ensure the controller recognizes the new sensor and the suspension operates correctly.

  7. Test operation

    Start the tractor and test the front suspension through its full range of motion to confirm the repair has been successful and the fault code does not reappear.

Parts you might need

(4)

Get help to fix this fault by requesting a quote

Browse other New Holland codes