New Holland 1511 – VCM / IC: Right Brake Light Open Circuit
Issue description
The control system has detected a loss of electrical continuity (an open circuit) in the right-hand brake light circuit. This indicates a break or disconnection in the electrical path that supplies power to the right brake light, preventing it from illuminating when the brakes are applied. The fault is logged when the system fails to detect the expected electrical load from the brake light bulb.
Applies to these machines
40 machines- L213
- L215
- L216
- L218
- L220
- L221
- L223
- L225
- L228
- L230
- L234
- L313
- L315
- L316
- L318
- L320
- L321
- L323
- L325
- L328
- L330
- L334
- C227
- C232
- C234
- C237
- C238
- C245
- C327
- C330
- C332
- C334
- C337
- C338
- C345
- C362
- Case SR Series
- Case SV Series
- Case TR Series
- Case TV Series
Check the cause
Inspect the right brake light bulb for a broken filament (most common cause)
Check for 12V power at the brake light socket terminal with the ignition on and brake pedal depressed
Verify the ground connection for the right tail light circuit has a clean, tight connection to the machine's chassis
Disconnect and inspect all electrical connectors in the circuit for corrosion, bent pins, or pushed-out pins
Visually trace and inspect the wiring harness from the right tail light to the main chassis for cuts, abrasions, pinching, or corrosion
Repair steps
Ensure machine safety
Park the machine on a level surface, lower all attachments to the ground, turn off the engine, engage the parking brake, and remove the key.
Access tail light assembly
Remove the screws or bolts securing the right tail light lens and housing.
Test or replace bulb
Remove the bulb and test it for continuity with a multimeter, or replace it with a known good bulb.
Repair wiring issues
If wiring is damaged, cut out the damaged section and splice in a new piece of wire of the same gauge using weatherproof butt connectors or solder and heat-shrink tubing. Replace any corroded connectors or pins.
Clean and secure connections
Clean any corrosion from bulb sockets and connector pins using a wire brush or electrical contact cleaner. Apply a small amount of dielectric grease and reconnect all connectors, ensuring they click into place and are fully seated.
Test the repair
Reinstall the bulb, turn the machine's ignition on, and activate the brake circuit to verify the right brake light illuminates.
Clear fault codes
Use the machine's diagnostic interface or a service tool to clear the 1511 fault code.
Reassemble
Reinstall the tail light housing and lens.
Parts you might need
(2)- Tail Lamp / Tail Light Assembly84239207
Verify fitment with machine serial number. Installation may require cutting old rusted bolts and using new hardware.
Tail Lamp / Tail Light Assembly
87627854Verify fitment with machine serial number. Installation may require cutting old rusted bolts and using new hardware.
Get help to fix this fault by requesting a quote