1512

New Holland 1512 – VCM / IC: Right Brake Light Shorted To Ground

Issue description

The control module has detected a short circuit to ground in the electrical circuit for the right-hand brake light. This means that the electrical current is finding an unintended path to the vehicle's chassis or ground before it reaches the brake light bulb, which typically causes the right brake light to be inoperative and may lead to a blown fuse.

Applies to these machines

  • SSL
  • CTL

Check the cause

  1. Visually inspect the right-hand tail light assembly, its connector, and the visible wiring harness for any signs of physical damage, corrosion, melted plastic, or chafing

  2. Check the fuse for the brake light circuit in the vehicle's fuse box (a blown fuse confirms a short circuit is present)

  3. Ensure the vehicle's battery is fully charged (at least 12.6V at rest) and that the main chassis ground straps are clean, tight, and free of corrosion

Repair steps

  1. Isolate the faulty component

    Turn the ignition on. Have a helper press the brake pedal, or use a brace to hold it down. Confirm that only the right brake light is not working to isolate the fault to that specific circuit.

  2. Test the bulb and lamp holder

    Disconnect power to the right tail light assembly and remove the brake light bulb. Inspect the filament and replace if broken. Visually inspect the bulb holder for corrosion and clean if necessary. Swap the bulb from the working left brake light to rule out a faulty bulb.

  3. Test for a short in the wiring harness

    Disconnect the wiring harness connector at the right tail light assembly. Set a multimeter to the continuity setting (audible beep or Ohms). Connect one probe to the power wire terminal in the harness connector and the other to a known good chassis ground. A beep or very low resistance reading confirms the power wire is shorted to ground.

  4. Locate and repair the short

    If a short is confirmed, trace the wiring harness from the tail light back towards the cab. Inspect areas where the harness passes through the frame, is secured by clips, or is exposed to debris/vibration. Look for chafed insulation touching the metal chassis. Repair any damaged wire using a weatherproof splice and seal with heat shrink tubing.

  5. Test the brake light switch

    If the harness is intact, locate the brake light switch near the brake pedal assembly. Disconnect its electrical connector and use a multimeter to check for continuity between the switch's terminals when the pedal is pressed, and no continuity when released. Replace the switch if it is internally shorted.

  6. Final verification

    Reconnect the tail light assembly. Install a new fuse of the correct amperage if the original was blown. Turn the ignition on and press the brake pedal to verify correct function. Clear the fault code from the control module using the appropriate diagnostic tool.

Parts you might need

(4)
  • Brake Light Bulb

    81867061

    12V, 21W. OEM part number example for T4050. Common wear item.

  • OEM part number example for T4050. Replace if internal holder is corroded beyond repair or housing is damaged.

  • Wiring Harness Connector / Pigtail

    If only the connector at the tail light is damaged, a replacement pigtail can be spliced into the existing harness. OEM part numbers are specific to connector type.

  • Brake Light Switch

    Located near the brake pedal. Part numbers are model-specific.

Get help to fix this fault by requesting a quote

Browse other New Holland codes