New Holland 1522 – VCM: Left Brake Light Shorted To Ground
Issue description
The electrical circuit for the left brake light has a short to ground, meaning the current is taking an unintended path to the vehicle's chassis or another ground point before reaching the brake light bulb. This condition results in a higher than normal current flow that is detected by the Vehicle Control Module (VCM), causing the left brake light to fail to illuminate or remain permanently off.
Applies to these machines
18 machines- L213
- L215
- L216
- L218
- L220
- L221
- L223
- L225
- L228
- L230
- L234
- C227
- C232
- C234
- C237
- C238
- C362
- L185
Check the cause
Visually inspect the wiring harness leading to the left brake light assembly for chafed, pinched, or melted insulation that could contact the frame.
Check the tail light connector and housing for signs of moisture intrusion or corrosion, especially if the machine was recently washed or operated in wet conditions.
Disconnect the left brake light assembly from the main wiring harness, clear the fault codes, and check if code 1522 returns. If it does not return, the fault is within the tail light assembly. If it returns, the short is in the machine's wiring harness.
With the brake light disconnected and the machine off, use a digital multimeter to check for continuity to ground on the left brake light power wire. Continuity confirms a short to ground in the wiring harness.
Repair steps
Repair wiring harness
If the short is isolated to the wiring harness, trace the affected wire from the brake light connector back towards the control module. Cut out the compromised portion, splice in a new piece of wire of the same gauge, and seal the repair with heat-shrink tubing. Secure and route the harness away from sharp edges or moving parts.
Replace bulb or tail light assembly
If the fault was isolated to the tail light assembly, inspect the bulb socket and internal wiring. Try installing a new bulb first. If the socket is corroded or damaged, replace the entire tail light assembly.
Clean and secure connectors
If moisture or corrosion was found in a connector, clean the terminals with electrical contact cleaner. Apply dielectric grease to the connector before reassembly to seal it from future moisture.
Clear codes and verify repair
Reconnect all components, start the machine, and use the diagnostic menu or an Electronic Service Tool (EST) to clear the fault codes. Operate the brake lights to visually confirm correct function and ensure the code does not return.
Parts you might need
(4)OEM New Holland part. Fits C227, C232, C238, C362, L218, L220, L221, L223, L225, L228, L230, L234.
Red Rear/Tail Stop Light Assembly
87627854OEM New Holland part (aftermarket replacements available). Fits C227, C232, C234, C237, C238, L213, L215, L216, L218, L220, L221, L223, L225, L228, L230, L234.
Bulb
87642985BULB 3157, 12V, 26.5W, Clear. Common bulb for models like the L185.
Lamp Socket
87642986For models like the L185.
Get help to fix this fault by requesting a quote