New Holland 15512 – IntelliSteer™ controller, Tractor Controller Unit (TCU), or Armrest Controller Module (ACM): Primary Steering Pressure Sensor Under Voltage
Issue description
The control module has detected an abnormally low voltage signal from the primary steering pressure sensor. This indicates that the sensor is receiving insufficient voltage, which can be caused by a faulty sensor, damaged wiring, or a problem with the controller itself.
Applies to these machines
15 machines- T6
- T7
- T8
- TJ330
- Farmall 60
- Farmall 70
- Farmall 80
- Farmall 90
- Farmall 95
- TD Series
- T6030
- T6050
- T6070
- TM125
- TM140
Check the cause
Check for other active fault codes related to sensor supply voltage or CAN bus communication to help pinpoint the root cause
Visually inspect the wiring harness and connectors leading to the primary steering pressure sensor for any visible damage, corrosion, or loose connections
Inspect the hydraulic fluid level and condition (while less likely to cause an electrical under-voltage fault, low or contaminated fluid can cause erratic pressure readings)
Repair steps
Locate the sensor
Find the primary steering pressure sensor on the steering system hydraulic lines. Depending on the model, it may be an inline flow switch between the steering pump and priority valve (often under the cab) or installed in a pressure gauge port tee on the orbitrol motor.
Test sensor wiring
Disconnect the sensor's electrical connector. With the key on, use a multimeter to test the voltage at the supply pin in the harness connector (should be a stable 5-volt or 12-volt reference). Verify the ground pin has good continuity to chassis ground, and check for a short circuit between the signal wire and ground wire.
Test the sensor
If the wiring provides the correct voltage and ground, test the sensor itself for an internal short.
Isolate and repair
If the supply voltage is low at the harness connector, trace and repair the issue upstream in the wiring or control module. If the supply voltage and ground are correct, replace the failed sensor. If replacing the sensor does not resolve the issue, diagnose or replace the steering control module.
Parts you might need
(6)Replaces 5099414, 84557955, 84557962. Fits Farmall and TD series tractors.
Fits T6030, T6050, T6070, TM125, and TM140.
- Steering Pressure Sensor375644A1
Fits New Holland TJ330 models.
Steering Control Assembly
383941Alternative part number 84439729.
Hydraulic Steering Unit
47376672- Power Steering Orbit Motor86585453
Alternative part numbers 81875266, E3NN3A244CB.
Get help to fix this fault by requesting a quote