15590

New Holland 15590 – Steering Controller: Secondary Steering System Hardware Not Detected

Issue description

The system has detected that auxiliary steering system equipment is not present or not functioning as expected. The auxiliary steering system is a safety feature designed to provide temporary steering control if the primary hydraulic steering system fails. This fault indicates an electrical circuit problem, such as a disconnected component, a wiring failure, or a faulty control module, rather than a purely hydraulic issue.

Applies to these machines

  • T6
  • T7
  • T8
  • T9
  • CR series
  • Wheel Loaders

Check the cause

  1. Visually inspect wiring harnesses and connectors for the secondary steering pump/motor, pressure switch, and control solenoids or valves for abrasions, pinch points, corrosion, or loose connections

  2. Scan for related fault codes, particularly CAN bus communication errors (e.g., code 14021), power supply issues, or other sensor failures

  3. Verify power supply to the secondary steering pump motor and control module, checking relevant fuses and relays

  4. Ensure all ground connections for secondary steering components are clean, tight, and free of corrosion

  5. Perform continuity and short circuit tests on the wiring harness between the main steering controller and secondary steering components

Repair steps

  1. Address basic wiring issues

    Repair any damaged wires or clean corroded connectors found during the visual inspection. Clear the fault codes and re-test the system to see if the fault returns.

  2. Test secondary steering pump

    Attempt to activate the pump via a diagnostic tool or manual test switch. Listen for the pump motor to run during the vehicle's power-on self-test. If the pump does not activate and it is receiving power, the pump motor itself may be faulty.

  3. Test pressure switch

    Use a multimeter to check the secondary steering pressure switch operation (normally open or normally closed). Verify that its state changes when the secondary steering system is activated and builds pressure.

  4. Investigate CAN bus communication

    If CAN communication fault codes are present, troubleshoot the network wiring harness and the secondary steering controller to restore communication with the main vehicle controllers.

  5. Replace faulty components

    If a specific component (pump, switch, or controller) is identified as faulty through testing, replace it with a new unit.

Parts you might need

(11)
  • Secondary Steering Pump/Motor Assembly

    OEM part highly recommended for critical safety systems. Verify fitment by serial number.

  • Secondary Steering Pressure Switch

    OEM part highly recommended. Verify fitment by serial number.

  • Secondary Steering Control Valve/Solenoid

    OEM part highly recommended. Verify fitment by serial number.

  • Wiring Harness

    Verify fitment by serial number.

  • Steering Controller

    Verify fitment by serial number.

  • Auxiliary Steering Module

    90515251

    Replaces 8603171. Fitment for W170B and likely other wheel loader models.

  • Auxiliary Steering Electric Pump

    87581480

    Replaces 380013A1.

  • Replaces 398888A1.

  • Auxiliary Steering Manifold

    87609806

    Replaces 87341296.

  • Secondary Steering Module Harness

    87323967

    Wire harness for secondary steering module.

  • Secondary Steering Module Harness

    84328472

    Replaces 84217688.

Get help to fix this fault by requesting a quote

Browse other New Holland codes