New Holland 16113 – ATC or Body Control Module: Outlet Sensor Open or Shorted to Power
Issue description
This fault code indicates an electrical failure related to a sensor on the output, most likely the transmission output shaft speed sensor. The control module has detected either an open circuit (a break in the wiring or sensor) or a short to the power supply (the signal wire has made contact with a power source). This prevents the sensor from functioning correctly and transmitting accurate data, which is critical for monitoring ground speed and ensuring correct gear shifting.
Applies to these machines
9 machines- T5
- T6
- T7
- T8
- T6020
- T7.210
- T8.390
- T6000
- T7000
Check the cause
Perform a visual inspection of the outlet temperature sensor and its wiring harness for frayed wires, loose connectors, or corrosion on the connector pins
Conduct a 'wiggle' test on the wiring harness and connector with the system powered on; if the fault code toggles, it indicates a loose connection or broken wire
Disconnect the sensor's electrical connector and inspect the pins for corrosion, moisture, or damage. Clean with electrical contact cleaner if necessary
Check for a short to power: With the sensor unplugged and key on, probe the signal wire. A reading of battery voltage (12V+) instead of the typical 5V reference indicates a short to power
Check for an open or shorted sensor: Measure the sensor's resistance (Ohms) with a multimeter. An 'OL' or infinite reading indicates an internal open circuit, while a zero or near-zero reading indicates an internal short
Repair steps
Power Down the System
For safety, always disconnect the battery or turn off the main power to the tractor before beginning any repair work.
Locate the Outlet Temperature Sensor
The exact location can vary by model. On many T-series tractors, A/C components, including sensors, are located within the HVAC housing, which may be under the operator's seat or within the cab roof assembly. A parts diagram or service manual for the specific tractor model is the best resource for precise location.
Access and Disconnect the Sensor
Once located, carefully disconnect the electrical connector from the sensor.
Remove the Old Sensor
The sensor is typically a probe-style component inserted into the ductwork or near the evaporator coil. It may be held in place by a clip or simply press-fit. Gently remove it.
Install the New Sensor
Insert the new outlet temperature sensor into the position of the old one, ensuring it is securely seated.
Reconnect and Secure
Reconnect the electrical connector, making sure it clicks into place to form a secure connection.
Clear Fault Codes
Reconnect the battery and power on the tractor. Use the tractor's diagnostic menu or a diagnostic tool to clear the 16113 fault code.
Verify the Repair
Operate the air conditioning system and monitor for the return of the fault code. Check for proper A/C operation.
Parts you might need
(6)Fits various T5, T6, T7, T6000, T7000, Maxxum, and Puma models.
Monitors air temperature within the HVAC system. Fits various T6, T7, T8, Puma, and Maxxum models.
Air Temperature Sensor Probe
Generic part name if specific OEM numbers do not match.
- Cab Temperature Sensor87454442
Measures return air temperature to the cab.
- Evaporator Temperature Sensor87754238
Positioned inside the evaporator core. Fits T6000, T7000, and Puma models.
- Thermostat Control Switch84240633
Aftermarket part referencing OEM number. Senses cab temperature and cycles the compressor.
Get help to fix this fault by requesting a quote