1823

New Holland 1823 – ECU: Camshaft Speed Sensor Low Voltage Amber

Issue description

The Engine Control Unit (ECU) has detected that the voltage from the camshaft position sensor is below the expected operational range. This sensor monitors the rotational position of the camshaft to precisely time fuel injection and ignition events. A low voltage condition, indicated by an amber warning, can disrupt the engine's timing system and lead to various engine performance issues.

Applies to these machines

  • L213
  • L218
  • L225
  • SR175
  • SV185
  • SR210
  • SV280
  • T4
  • T5
  • Boomer
  • Workmaster
  • Compact Track Loaders

Check the cause

  1. Visually inspect the camshaft position sensor, connector, and wiring harness for cracked insulation, exposed wires, or oil/moisture contamination

  2. Verify the sensor connector is securely fastened

  3. Check for a stable reference power supply (typically 5-volts) from the ECU to the sensor

  4. Check the ground circuit integrity between the harness ground pin and a clean engine block or chassis ground

  5. Check the signal wire for a weak or absent signal

Repair steps

  1. Prepare machine for testing

    Park the machine on a level surface, engage the parking brake, block the wheels, and locate the camshaft position sensor on the engine.

  2. Test sensor power (3-wire Hall-Effect sensors)

    With the sensor connected and the key in the 'ON' position (engine off), set a multimeter to DC Volts. Back-probe the connector's power wire and connect the other lead to a known good ground. It should read approximately 5V. If no voltage is present, inspect the wiring or ECU power supply.

  3. Test sensor ground (3-wire Hall-Effect sensors)

    With the key still ON, move the multimeter's positive lead to the ground wire at the connector. A reading near 0 volts indicates a good ground connection.

  4. Test sensor signal (3-wire Hall-Effect sensors)

    Keep the multimeter on DC Volts and back-probe the signal wire and the ground wire while a helper cranks the engine. The voltage should pulse rapidly between 0V and 5V. If it remains consistently low or zero, and power/ground are good, replace the sensor.

  5. Test internal resistance (2-wire Variable Reluctance sensors)

    Disconnect the sensor and measure resistance across the two pins. Compare to the service manual (typically 800-1500 ohms). A reading of zero (short) or OL (open) means the sensor is bad and must be replaced.

  6. Test AC voltage output (2-wire Variable Reluctance sensors)

    Reconnect the sensor, set the multimeter to AC Volts, back-probe the wires, and crank the engine. Expect 0.5V-1.5V increasing with engine speed. If no AC voltage is present, replace the sensor.

  7. Inspect Engine Control Unit (ECU)

    If the sensor and all wiring test correctly, the fault may lie within the ECU. This is less common and requires advanced diagnostics.

Parts you might need

(4)
  • Listed for T4/T5 tractors and L225 skid steer. Verification required.

  • Listed for Boomer and Workmaster compact tractors. Verification required.

  • Fits SR210, SV280, and T4/T5 tractors. Verification required.

  • Camshaft Position Sensor

    47709971

    Listed for Case IH / New Holland. Verification required.

Get help to fix this fault by requesting a quote

Browse other New Holland codes