New Holland 19055 – DCU: UREA Temperature Sensor Signal High
Issue description
The Dosing Control Unit (DCU) is receiving a voltage from the urea temperature sensor that is above the normal operating range. This indicates an abnormal temperature reading, typically caused by a short circuit in the sensor's wiring or an internal failure of the sensor itself. The sensor monitors Diesel Exhaust Fluid (DEF) temperature, which is critical for the SCR system to inject fluid within the effective temperature range.
Applies to these machines
6 machines- T7.210
- T7.225
- T7.230
- T7.245
- T7.260
- T7.270
Check the cause
Use a diagnostic tool to verify that fault code 19055 is active or has a high occurrence count, and note any other related fault codes that may be present.
Visually inspect the wiring harness and connectors associated with the DEF pump module and urea temperature sensor for chafing, pinching, corrosion, or loose connections. Pay close attention to areas where the harness may rub against the chassis or other components.
Disconnect the relevant connectors and inspect for moisture or DEF (urea) contamination on the pins, which can cause a short circuit.
With the ignition on, use a multimeter to check the voltage at the sensor's signal wire. A reading significantly higher than the specified range (typically above 5V) confirms a short to a higher voltage source.
Check for continuity on the wiring between the sensor and the DCU to identify any open circuits or shorts.
Measure the resistance of the temperature sensor and compare it to the manufacturer's specifications. An infinite resistance reading indicates an open circuit within the sensor.
Repair steps
Disconnect power
Ensure the vehicle's ignition is off and the battery is disconnected before beginning any electrical repairs.
Locate the DEF pump module
Locate the DEF pump module on the chassis, near the DEF tank. On T7 series tractors, it is a distinct unit with several electrical and fluid connections.
Clean and reseat connectors
If the initial inspection reveals potential connector issues, clean the pins with a suitable electrical contact cleaner and ensure a secure connection. Clear the fault codes and operate the machine to see if the fault returns.
Repair wiring
If damaged wiring is found, repair or replace the affected section of the harness. Ensure all repairs are properly insulated and secured to prevent future damage.
Replace the DEF pump module
If the diagnostic checks point to a faulty sensor, the entire DEF pump/dosing module must be replaced, as the urea temperature sensor is integrated into the module and is not available as a separate part.
Program the new module
After replacing the DEF pump module, program it to the vehicle using a New Holland diagnostic tool.
Clear codes and test
After completing the repairs, reconnect the battery, clear all fault codes, and operate the machine to ensure the fault has been resolved.
Parts you might need
(10)DEF Pump / Dosing Module
0444042210Bosch OEM part, common for New Holland T7 series
DEF Dosing Module
0444023058Bosch OEM part, potential alternative for Case New Holland equipment
- Temperature Sender5801960832
Listed for New Holland T7.210, but specific application to the DEF system is not confirmed
Urea Sensor
5802862328Listed for New Holland Construction equipment. Verify fitment with dealer.
- DEF Tank Level and Temperature Sensor5802862326
Fits T6, T7, combines, and harvesters. Associated with DEF supply module.
Temperature Sensor
SBA185746100Potential related sensor, verify exact part number with dealer.
- Temperature Sensor87695841
Potential related sensor, verify exact part number with dealer.
- Temperature Sensor47598516
Potential related sensor, verify exact part number with dealer.
- Temperature Sensor504088112
Potential related sensor, verify exact part number with dealer.
- Temperature SensorSBA385720070
Potential related sensor, verify exact part number with dealer.
Get help to fix this fault by requesting a quote