19742

New Holland 19742 – ECM: ECM/PCM Power Relay Control Circuit Open - Main Relay Shut Off Too Early

Issue description

The ECM/PCM Power Relay Control Circuit is open, causing the Main Relay to shut off too early. This interrupts the power supply to the Engine Control Module (ECM) or Powertrain Control Module (PCM) when it should have remained powered. This issue affects the power supply to the engine control module, potentially leading to the check engine light illuminating, intermittent engine stalling, hard starting, or a complete failure of the engine to start.

Applies to these machines

  • T7.210
  • T7.220
  • T7.235
  • T7.250
  • T7.260
  • T7.270
  • T7.315
  • T7030
  • T8.275
  • T8.300
  • T8.330
  • T8.360
  • T8.390
  • T8.420
  • T8000

Check the cause

  1. Verify the active fault code 19742 (or P0685) using an OBD-II scanner or New Holland Electronic Service Tool (EST), noting any accompanying codes.

  2. Check for blown fuses related to the ECM/PCM (often located behind the operator's seat in T7 and T8 models).

  3. Visually inspect the main power relay and associated wiring for corrosion, melted plastic, chafing, or breaks (check relay R13 in T7030 models or the engine compartment relay box in T8000 models).

  4. Test the relay circuit with a multimeter to verify correct voltage and ground signals at the relay socket.

Repair steps

  1. Disconnect battery

    Before beginning any electrical repairs, disconnect the battery to prevent electrical shorts.

  2. Replace blown fuses

    If any blown fuses were found during inspection, replace them with new fuses of the exact same amperage rating. Never use a fuse with a higher rating.

  3. Replace main relay

    If the main relay is suspected to be faulty, replace it with the correct part for your specific model and serial number.

  4. Repair wiring harness

    Repair or replace any damaged wiring sections. Ensure all connections are clean and secure, and apply dielectric grease to connector pins to prevent future corrosion.

  5. Clear codes and test

    Reconnect the battery, use a diagnostic tool to clear the fault code, and run the engine to ensure the fault does not return.

Parts you might need

(6)
  • 20 Amp Relay86509590

    For T8 Series (T8.275, T8.300, T8.330, T8.360, T8.390, T8.420)

  • Main Power Relay

    87582879

    Replaced by 87696396. For various T8 models including T8.420, T8.360, T8.275, T8.390, T8.330, and T8.300.

  • 20 Amp Micro Relay

    90338514

    Replaces 84543528. For T7.210 models.

  • For T7.315

  • 70 Amp Relay82012872

    For various New Holland models

  • Potential alternative relay

Get help to fix this fault by requesting a quote

Browse other New Holland codes