New Holland 19804 – DCU or ECU/ECM: DEF Tank Temp Sensor Open Circuit
Issue description
The system detects invalid temperature data in the urea (DEF) tank due to an open circuit. This indicates a break in the electrical circuit connecting the temperature sensor to the control module, preventing the module from receiving a valid temperature signal. The Engine Control Unit (ECU) or Dosing Control Unit (DCU) relies on this data to maintain optimal DEF temperature for the Selective Catalytic Reduction (SCR) system to function correctly and control exhaust emissions.
Applies to these machines
5 machines- Tier 4B SCR Machines
- Tractors
- Loaders
- Combines
- Skid Steer Loaders
Check the cause
Visually inspect the wiring harness and connectors between the DEF tank temperature sensor and the control module for chafing, melting, or corrosion.
Use a diagnostic scanner to check for other active SCR system fault codes (such as P205D) that may indicate broader system issues.
Verify DEF quality, as poor quality or old DEF can lead to crystallization and system issues.
Use a digital multimeter to test for an open circuit or high resistance in the ground and signal circuits between the DCU and the urea tank temperature sensor (look for 4.6 - 5.2 V at the connector).
Inspect the DEF tank heater control valve; check if coolant lines running to the DEF tank are warm when they shouldn't be, indicating a stuck valve.
Repair steps
Gain access to sensor
Safely access the DEF tank and the associated temperature sensor. This may require removing protective covers.
Disconnect and inspect connector
Disconnect the electrical connector from the temperature sensor. Inspect the connector pins for corrosion or damage.
Test the circuit voltage
With the ignition on, use a multimeter to check for the correct voltage (typically 4.6 - 5.2 V) at the sensor connector to confirm the integrity of the wiring from the control module.
Test the sensor resistance
If the wiring is intact, measure the sensor's resistance and compare it to manufacturer specifications to determine if the sensor has failed internally.
Replace faulty component
Repair or replace the affected section of the wiring harness if damaged. If the sensor is determined to be faulty, replace it (note that the temperature sensor is often integrated with the DEF level sensor).
Clear fault codes
After the repair, use a diagnostic tool to clear the fault code from the DCU/ECU.
Perform a drive cycle
Operate the machine under load for 20-45 minutes to allow the SCR system to reach operating temperature and verify that the repair is successful and the fault does not reappear.
Parts you might need
(5)- DEF Tank Level and Temperature Sensor5802862326
Listed for Case IH Farmall models, which share components with New Holland tractors.
- Temperature Sensor82017881
Used across a wide range of New Holland loaders, combines, and tractors.
Temperature Sensor
SBA185746100Replaces 84568821; used on various New Holland skid steer loaders.
- Temperature SensorSBA385720070
New Holland sensor, specific urea tank application unconfirmed.
- Temperature SensorSBA385720011
New Holland sensor, specific urea tank application unconfirmed.
Get help to fix this fault by requesting a quote