2038

New Holland 2038 – XCM: Clutch B Solenoid Short to +12V

Issue description

The transmission's Clutch B solenoid valve is experiencing a short circuit to the +12 volt power supply. This electrical fault causes the solenoid to receive continuous voltage, leading to improper operation of the clutch system. If not addressed, this condition can result in shifting issues and potential system failure or damage to the transmission.

Applies to these machines

  • T5.95
  • T5.105
  • T5.115
  • TL70
  • TL80
  • TL90
  • TL100
  • TL70A
  • TL80A
  • TL90A
  • TL100A
  • T5030
  • T5040
  • T5050
  • T5060
  • T5070

Check the cause

  1. Carefully inspect the wiring harness leading to the Clutch B solenoid valve on the transmission for any signs of damage, such as chafing, melting, or corrosion on the connectors.

  2. Disconnect the wiring harness from the Clutch B solenoid and use a multimeter to check for continuity between the signal wire pin on the harness connector and a known good ground (continuity indicates a short in the wiring harness).

  3. With the solenoid disconnected, use a multimeter to measure the resistance across the two terminals of the solenoid itself. A typical reading is between 8 and 11 Ohms; readings significantly outside this range, zero, or infinite resistance suggest a faulty solenoid.

  4. Briefly apply a 12V power source to the solenoid terminals to perform an activation test. You should hear a distinct 'click' as the internal valve actuates. The absence of a click indicates a seized or burnt-out solenoid (only apply power momentarily to avoid damaging the coil).

Repair steps

  1. Drain hydraulic fluid

    Drain the transmission hydraulic fluid to prepare for the removal of the transmission control components.

  2. Disconnect hydraulic lines

    Disconnect the necessary hydraulic lines to gain access to the transmission control valve block.

  3. Remove valve block

    Remove the transmission control valve block to access the transmission solenoids.

  4. Replace solenoid valve

    Replace the faulty Clutch B solenoid valve. Reassemble the valve block and lines. It is highly recommended to consult the official New Holland service manual for specific tools and torque specifications during this process.

Parts you might need

(3)
  • OEM part number. Cross-references: 5144771, 5139049, 47125301, 84488341. 12V DC electro-hydraulic spool valve, typically with a 2-pin sealed connector.

  • Potential part number for TL/TN series. Verify correct part number with a dealer using your tractor's serial number.

  • Potential part number for T5 series. Verify correct part number with a dealer using your tractor's serial number.

Get help to fix this fault by requesting a quote

Browse other New Holland codes