New Holland 2052 – TCM: Transmission Oil Temp Sensor Short to Ground
Issue description
The Transmission Control Module (TCM) has detected a short circuit to ground in the electrical circuit of the transmission oil temperature sensor. This indicates the sensor's signal wire is likely making direct contact with the vehicle's chassis or another ground path, causing an abnormally low voltage reading. The control unit interprets this invalid signal as a fault. The transmission oil temperature sensor's function is to monitor the temperature of the transmission fluid and send this data to the control module, which then uses it to regulate transmission functions and prevent overheating.
Applies to these machines
47 machines- 5640
- 8160
- 8260
- 8360
- 8560
- TS90
- TS100
- TS115
- TS90E
- TS100E
- TS115E
- TL70
- TL80
- TL90
- TL100
- TM110
- TM115
- TM120
- TM125
- TM130
- TM135
- TM140
- TM150
- TM155
- TM165
- TM180
- T6030
- T6050
- T6070
- T6080
- T6090
- T6095
- T7030
- T7040
- T7050
- T7060
- T7070
- T7.170
- T7.185
- T7.200
- T7.210
- T7.220
- T7.230
- T7.235
- T7.250
- T7.260
- T7.270
Check the cause
Visually inspect the wiring harness leading to the transmission oil temperature sensor for chafing, cuts, melting, or corrosion, paying close attention to areas rubbing against the frame.
Verify the sensor signal on a cold engine via the tractor's diagnostic display; compare the reading with engine coolant or hydraulic oil temperature. All readings should be very close to ambient air temperature. A significantly lower or default minimum reading suggests a fault.
Check for a 5-volt reference supply at the disconnected harness connector with the ignition ON (engine off). One of the pins should have approximately 5 volts relative to a good chassis ground. If missing, there may be an issue with the control module or a break in the supply wire.
Test the disconnected sensor's resistance (Ohms) across its terminals; an open circuit (infinite) or internal short (zero ohms) indicates a faulty sensor.
Check for a short to ground by testing continuity between the signal wire in the harness connector and a clean chassis ground with the ignition off. If the multimeter beeps or shows a low resistance reading, it confirms the signal wire is shorted to ground somewhere in the harness.
Repair steps
Prepare machine for service
Park the tractor on a level surface, turn off the engine, engage the parking brake, and allow the transmission to cool completely to avoid burns.
Locate the sensor
Find the transmission oil temperature sensor, which is typically threaded into the transmission housing or a related component like the filter head.
Repair wiring harness
If diagnostic checks revealed a short in the wiring, cut out the damaged section, splice in a new wire of the same gauge using heat-shrink tubing or connectors, and secure the harness away from sharp edges or moving parts.
Replace the temperature sensor
If the sensor is faulty, place a drain pan underneath, disconnect the electrical connector, and unscrew the old sensor. Clean the threads, apply thread sealant to the new sensor (unless it comes with a pre-applied sealant or sealing washer), install it to the specified torque, and reconnect the wiring.
Clear codes and verify repair
Use the diagnostic system to clear fault code 2052. Start the tractor, monitor the transmission oil temperature reading to ensure it rises plausibly as the transmission warms up, and check for fluid leaks around the new sensor.
Parts you might need
(6)Potential OEM part number. Verify exact part with dealer using serial number.
Potential OEM part number. Verify exact part with dealer using serial number.
Potential OEM part number. Verify exact part with dealer using serial number.
Potential OEM part number. Verify exact part with dealer using serial number.
Potential OEM part number for TS Series. Verify exact part with dealer using serial number.
Transmission Oil Temperature Sensor (Aftermarket)
S.151366Sparex aftermarket replacement cross-referencing OEM 82018569 and 87564690.
Get help to fix this fault by requesting a quote