2056

New Holland 2056 – TCM: Low Range Switch Open

Issue description

The Transmission Control Module (TCM) has detected an open circuit for the low range switch. This indicates that the controller is not receiving the expected electrical signal confirming the low range gear is engaged, which can prevent proper transmission operation. The underlying condition is typically a break in the wiring, a faulty switch, or a problem with the switch's connector.

Applies to these machines

  • T6000 Series
  • T6010
  • T6020
  • T6030
  • T6040
  • T6050
  • T6060
  • T6070
  • 40 Series
  • 5640
  • TS-A Series
  • Boomer Series
  • 4055
  • 4060
  • TM Series
  • T7000 Series

Check the cause

  1. Perform On-Board Diagnostics (H-Menu) using Tool No. 4FT 950 connected to the diagnostic port. With the key on, verify the display shows 'HH'. Navigate to the 'H5' Switch Test menu (display will initially show 'd0'). Operate the low range selector and verify if code 'd82' appears with an audible tone.

  2. Visually inspect the wiring harness leading to the transmission case and the low range switch for chafing, breaks, or corrosion.

  3. Disconnect and inspect the low range switch connector (a 4-way connector on 40 Series models) for corrosion, moisture, or damaged pins. Ensure it is securely connected.

  4. Check the range selection linkage for excessive play or incorrect adjustment that might prevent the switch from being physically activated.

Repair steps

  1. Ensure safety

    Park the tractor on a level surface, engage the parking brake, and disconnect the battery before beginning any electrical repairs.

  2. Locate the switch

    Find the low range switch (identified as S17 in some T6000 series schematics) on the exterior of the transmission case, where it can be activated by the range selection mechanism.

  3. Test the circuit

    Using a multimeter and wiring diagram, perform continuity tests on the wires between the switch connector and the transmission controller to rule out a wiring break.

  4. Replace the switch

    Disconnect the electrical connector, unscrew the old switch (be prepared for a small oil leak), clean the threads on the transmission case, install the new switch to manufacturer specifications, and reconnect the electrical connector.

  5. Final verification

    Reconnect the battery, turn the ignition on and re-enter the H5 diagnostic menu to confirm that the 'd82' code now appears when low range is selected. Clear the stored fault codes using the HC menu routine, start the tractor and test for proper operation in all ranges.

Parts you might need

(5)
  • Superseded by 87369252. General switch for TS and T6 models.

  • Supersedes 82020684. General switch for TS and T6 models.

  • Compatible with a wide range of T6000 and T7000 models.

  • Low Pressure Switch

    87323829

    Compatible with a wide range of T6000 and T7000 models.

  • Range Gear Switch / Transmission Low Range Switch

    Generic part name. Verify exact part number with dealer using serial number.

Get help to fix this fault by requesting a quote

Browse other New Holland codes