22

New Holland 22 – TMF: Single Draft Pin Sensor Failure

Issue description

The electronic draft control (EDC) system has detected a failure in the single draft pin sensor when the tractor is configured to use only one draft pin sensor. This sensor measures the draft force on the three-point hitch, allowing the control module to automatically adjust hitch height. A failure indicates the sensor is not functioning properly, which may cause incorrect readings, system malfunctions, and impaired implement performance.

Applies to these machines

  • T5
  • T6
  • T7
  • T8
  • TG Series
  • TM Series
  • 8670A
  • 8770A
  • 8870A
  • 8970A

Check the cause

  1. Visually inspect the draft pin sensor and its wiring harness for frayed or broken wires, corrosion on the connector pins, and physical damage.

  2. Ensure the electrical connector to the draft pin sensor is clean and securely fastened.

  3. Inspect system grounds (main chassis and cab grounds) to ensure they are clean, tight, and free of corrosion.

  4. Check the 5-volt sensor supply line from the controller for faults (related to fault codes 14 and 15).

  5. Review the system for other active or stored fault codes related to hitch position potentiometers or communication errors.

Repair steps

  1. Disconnect the sensor

    Safely secure the three-point hitch and disconnect the electrical connector from the draft pin sensor.

  2. Test the sensor

    Test the sensor's internal strain gauge for correct resistance values using specifications from the service manual.

  3. Replace the draft pin sensor

    If the sensor is faulty, remove the retaining pin or bolt, slide the old sensor out of the draft arm, install the new sensor, and secure it with the retainer.

  4. Reconnect and clear codes

    Reconnect the electrical harness to the new sensor. Start the tractor and use the instrument cluster or a diagnostic tool to clear the fault codes.

  5. Perform calibration

    Perform a hitch calibration through the tractor's service menu ('H' routines) to ensure the controller recognizes the new sensor's output correctly.

Parts you might need

(4)
  • OEM CNH Industrial part. Alternate/superseded numbers include 9820913, 322022A1, 84385145, 87312146, 47128313, 5184322, and 87314754. Verify fitment with serial number.

  • Draft Load Sensing Pin Elimination Kit

    8302386

    Hy-Capacity part number. Bypasses draft sensing function if automatic draft control is not critical. Alternate part: HA87661289 (Greater Ag Parts).

  • Alternative part number: LBT00-10192

  • Replaces older part numbers 87393065, 87567066C, 87615859, 87339221

Get help to fix this fault by requesting a quote

Browse other New Holland codes