2338

New Holland 2338 – TCU: Slow Speed Potentiometer - Short Circuit to +8 V or +12 V

Issue description

The Transmission Control Unit (TCU) has detected a short circuit in the creeper speed control potentiometer. The signal wire is likely making an unintended connection to a +8 V or +12 V power supply wire, resulting in an abnormally high voltage reading. This prevents the control system from accurately determining the operator's desired creeper speed, causing improper operation of the slow speed control system.

Applies to these machines

  • T7.170
  • T7.185
  • T7.200
  • T7.210
  • T7.220
  • T7.230
  • T7.235
  • T7.245
  • T7.250
  • T7.260
  • T7.270
  • T4
  • T5
  • T6
  • TM
  • TM115
  • TM130
  • TM150
  • TM165
  • T4020V
  • T4030
  • T4030F
  • T4050F
  • T6.140
  • T6080
  • T7030
  • T7050

Check the cause

  1. Visually inspect the wiring harness leading to the creeper potentiometer on the right-hand control console for chafed or melted insulation, pinched wires, or corrosion in the connectors.

  2. Check the tractor's diagnostic menu for other fault codes; multiple voltage-related faults may indicate a systemic electrical issue rather than an isolated component failure.

  3. Perform an electrical resistance test on the disconnected potentiometer using a multimeter. Check total resistance across the outer terminals, then test the center terminal (wiper) against an outer terminal through its full range of motion to check for erratic readings or dead spots.

  4. Use the tractor's H-Menu diagnostics (e.g., menu H3, channel 29 on T7 series) to monitor the creeper position potentiometer status and verify if the controller is receiving a valid signal.

Repair steps

  1. Safety First

    Ensure the tractor is parked on a level surface, the parking brake is engaged, and the engine is turned off. Disconnect the battery before working on electrical components.

  2. Locate and Access the Potentiometer

    Remove panels on the armrest or right-hand console where the creeper controls are located to access the potentiometer.

  3. Perform Diagnostic Tests

    Conduct the visual inspection and electrical tests on the potentiometer and its wiring as described above.

  4. Repair Wiring

    If the diagnostic tests reveal a short in the wiring harness, repair the damaged section using appropriate connectors and heat shrink for a durable, insulated repair.

  5. Replace the Potentiometer

    If the potentiometer is found to be faulty, disconnect the electrical connector, remove the mounting hardware, and install the new component.

  6. Reassemble and Reconnect

    Reinstall any panels that were removed and reconnect the battery.

  7. Calibrate if Necessary

    After replacing the potentiometer, a calibration may be required. Perform a calibration routine through the tractor's diagnostic menu or by a qualified technician to ensure smooth operation.

Parts you might need

(5)
  • Genuine CNH Industrial Part. Supersedes previous part numbers 87559692, 82033385, 82021036, and 82010303.

  • Creeper Potentiometer

    86729675

    Potential OEM part number. Verify fitment with dealer using tractor serial number.

  • Potential OEM part number. Verify fitment with dealer using tractor serial number.

  • Potential OEM part number. Verify fitment with dealer using tractor serial number.

  • Potential OEM part number. Verify fitment with dealer using tractor serial number.

Get help to fix this fault by requesting a quote

Browse other New Holland codes