2352

New Holland 2352 – TCU: Transmission Powershift Electrical Control Overvoltage in Clutch A Solenoid

Issue description

The system has detected an overvoltage condition in the electrical circuit for the Clutch A solenoid of the powershift transmission. The controller has detected that the solenoid is shorted to a +12 volt source even when it is not activated, indicating an abnormally high voltage that prevents proper electronic control of the clutch.

Applies to these machines

  • TM series
  • TM115
  • TM120
  • TM125
  • TM130
  • TM135
  • TM140
  • TM150
  • TM155
  • TM165
  • TM190
  • 60 Series
  • 8160
  • 8260
  • 8360
  • 8560
  • M Series
  • TS Series
  • TL Series
  • TL80
  • TS110

Check the cause

  1. Check for other active fault codes that could indicate a broader charging system or controller issue

  2. Verify the tractor's alternator is not overcharging, which can cause an overvoltage condition across multiple components

  3. Visually inspect the wiring harness leading to the transmission solenoids for chafing, melting, or corrosion that could cause a short circuit

  4. Inspect the main connectors at the Central Controller (XCM), specifically C533 and C535, and the Clutch A solenoid connector (C028) for secure, clean connections

  5. Perform a harness voltage test: disconnect XCM connector C535 and measure voltage between pin 14 (wire WS) and a known good ground. If +12V is present with the solenoid off, it confirms a short in the wiring harness

  6. Perform a solenoid resistance test: disconnect the solenoid and measure resistance across its two terminals, comparing the reading to manufacturer specifications

Repair steps

  1. Repair wiring or charging system

    If diagnostic checks reveal an overcharging alternator, damaged wiring harness, or loose/corroded connectors, repair or replace these components first.

  2. Replace Clutch A solenoid

    If the solenoid fails the resistance test, replace it. The transmission solenoids are located in a valve block on the side of the transmission (access may require draining some transmission fluid).

  3. Replace Central Controller (XCM)

    If the harness and solenoid are confirmed to be in good working order, replace the XCM as a last resort. This will require downloading software and calibrating it to the specific tractor.

  4. Clear fault codes

    After the repair has been completed, clear all fault codes from the controller's memory.

  5. Calibrate and test transmission

    After replacing a transmission solenoid or the XCM, perform a transmission clutch calibration to ensure smooth engagement. Operate the tractor to verify normal function.

Parts you might need

(3)
  • For TM, TS, TL, M, and 60 Series. Cross-references include 5144771, 5139049, 47125301, and 84488341.

  • For 8160, 8260, 8360, 8560 and TM115-TM165.

  • Transmission Solenoid Valve

    87456901

    General transmission solenoid valve for New Holland Agriculture.

Get help to fix this fault by requesting a quote

Browse other New Holland codes