2353

New Holland 2353 – TCU: Overvoltage in Clutch B Solenoid Circuit

Issue description

The control system has detected an overvoltage condition in the electrical control circuit for the Clutch B Solenoid. Specifically, the circuit is shorted to +12 volts when the activation is commanded off, meaning it is receiving voltage when it should not. This indicates a fault in the power supply or the wiring associated with the clutch solenoid, and may cause the Engine Control Module (ECM) to illuminate the amber CHECK ENGINE lamp.

Applies to these machines

  • T9
  • B90B
  • B95B
  • B95C
  • B100B
  • B110
  • B110B
  • B110C
  • LB75.B

Check the cause

  1. Verify the fault code is active or has a high occurrence count using an electronic service tool

  2. Visually inspect the wiring harness leading to the clutch B (or 1R) solenoid for chafing, melting, or corrosion that could cause a short to power

  3. With the keyswitch on, engine off, and solenoid commanded off, use a multimeter to test the signal wire at the solenoid connector for voltage (should be 0V; presence of voltage confirms a short to power)

  4. Isolate the circuit by disconnecting the harness from the control module and the solenoid, then check for continuity between the solenoid signal wire and any power supply wires within the harness

  5. Test the solenoid's internal resistance with a multimeter and compare it to OEM specifications to rule out an internal short

Repair steps

  1. Disconnect battery

    Disconnect the battery before performing any electrical repairs to ensure safety.

  2. Locate the solenoid

    Identify the Clutch B (or Clutch 1R) solenoid on the transmission control valve block.

  3. Repair wiring harness

    If diagnostic checks revealed a short to power in the wiring, repair or replace the damaged section of the harness. Ensure all connections are clean, secure, and properly insulated.

  4. Replace the solenoid

    If the solenoid fails the resistance test indicating an internal short, replace the solenoid assembly.

  5. Replace control module

    If the wiring and solenoid are confirmed to be good, the fault may lie within the Transmission Control Unit (TCU/ECM). Replace and program the module as a last resort.

  6. Clear codes and test

    Reconnect the battery and use an electronic service tool to clear the fault codes. Start the machine and operate it to ensure the fault does not return. A key cycle and a minute of idle time may be required for the system to re-validate the circuit.

Parts you might need

(4)
  • Controls hydraulic pressure for clutch engagement.

  • Solenoid87701329

    Fits New Holland backhoe loaders B90B, B95B, B95C, B110B, B110C, and others.

  • Used in PTO clutch control valves and transmission control valves on a wide range of models.

  • Aftermarket fit for models including B110, B110B, B100B, B95B, LB75.B, and others.

Get help to fix this fault by requesting a quote

Browse other New Holland codes