New Holland 2401 – TCU: Middle Row/Reverse Gear Synchronizer Not Calibrated or Incorrectly Calibrated
Issue description
The middle row/reverse gear synchronizer within the Semi-Powershift transmission has not been calibrated or its calibration data is incorrect. The Transmission Control Unit (TCU) lacks precise position and engagement data for the synchronizer, which can lead to harsh shifting, improper gear engagement, or a failure to shift into the affected ranges.
Applies to these machines
16 machines- T7 Series
- T7.210
- TM Series
- TM120
- TM130
- TM140
- TM155
- TM165
- TM175
- TM190
- T7000 Series
- T7030
- T7040
- T7050
- T7060 without Sidewinder
- MXM Series
Check the cause
Check transmission oil temperature (must be between 10°C and 60°C; check via diagnostic menus like H9).
Verify battery voltage is sufficient and chassis connections are clean and tight to prevent ghost codes.
Ensure the parking brake is engaged, as it acts as a safety interlock for calibration.
Confirm the shuttle lever is in the neutral position.
Ensure the operator is in the seat to activate the operator presence switch.
Ensure the engine speed can be set to the required 1200 RPM for the calibration process.
Check for and resolve any other active fault codes (especially transmission sensor, solenoid, wiring, or 'U' codes) before attempting calibration.
Repair steps
Warm up the tractor
Operate the tractor until the transmission oil reaches the required temperature (between 10°C and 60°C).
Position the tractor
Park the tractor on level ground and engage the parking brake.
Enter Calibration Mode
With the tractor off, place the shuttle lever in Neutral. Press and hold both the upshift and downshift buttons. While holding the buttons, start the engine and then release the buttons.
Initiate Automatic Calibration (Common on T7 and modern series)
Carefully release the clutch pedal. Depress the upshift button again until the display changes to 'Dt'. Depress the clutch pedal and move the shuttle lever to the forward position, then release the clutch. Momentarily press the 'Auto' function switch. The engine speed should automatically increase to approximately 1200 RPM, and the calibration will begin.
Monitor Automatic Calibration
The transmission will automatically calibrate the clutches one by one. If an error occurs, a code will be displayed.
Perform Manual Calibration (Common on TM and older series)
Adjust the engine RPM to 1200 +/- 50 RPM and place the shuttle lever in FORWARD. Press the upshift button to select the first clutch (e.g., 'A'). Press and hold the downshift button to calibrate until the engine speed decreases slightly and the display alternates between the clutch letter and a value. Release the downshift button and repeat for all clutches (B, C, D, E, F). Finalize calibration of the synchronizers until 'CF' appears.
Complete and Store
When the sequence is finished and 'End' or 'CF' appears on the display, turn the key off and wait at least 10 seconds for the new calibration values to be stored in the TCU.
Replace synchronizer potentiometer
If the calibration repeatedly fails or if other fault codes related to synchronizer position are present (e.g., codes 2415, 2416, 2419), replace the synchronizer potentiometer.
Parts you might need
(4)- Synchronizer Potentiometer3980855
Listed for MXM120, MXM130, MXM140 models
- Synchronizer Potentiometer84218029
Replaces 84172820. Listed for various Case IH and New Holland equipment
- Synchronizer Potentiometer86977396
General purpose potentiometer
- Synchronizer Potentiometer82037674
Genuine New Holland potentiometer
Get help to fix this fault by requesting a quote