2407

New Holland 2407 – TCU: Range Shift Synchroniser Engagement Failure

Issue description

The transmission control unit (TCU) commanded a range shift synchronizer to engage during a forward/reverse shuttle maneuver, but the corresponding sensor did not confirm that the action was completed successfully within the expected timeframe. This failure to engage can result in improper gear engagement, harsh shifting, an inability to select a range, or the transmission defaulting to neutral.

Applies to these machines

  • T7.170
  • T7.185
  • T7.200
  • T7.210
  • T7.235
  • T7.250
  • T7030
  • T7040
  • T7050
  • T7060
  • Puma 165
  • Puma 180
  • Puma 195
  • Puma 210
  • Puma 225

Check the cause

  1. Check for other active engine, transmission, or electrical codes (especially codes 2415, 2416, 2417, and 2418, which point to faults in the synchronizer potentiometer circuits)

  2. Verify transmission oil level and condition to ensure proper hydraulic pressure and component performance

  3. Check electrical system voltage (ensure battery is above 12.5V) and verify all main power and ground connections to the chassis and control modules are clean and tight

  4. Visually inspect the wiring harness and connectors leading to the transmission, specifically around the range shift solenoids and synchronizer position sensors, for corrosion, moisture ingress, or physical damage

  5. Test the synchronizer potentiometer using an ohmmeter to check for a smooth change in resistance as the component moves, or verify its 0-5V signal is proportional to the synchronizer's position

Repair steps

  1. Warm up the tractor

    Ensure the transmission oil temperature is within the specific range required for calibration (typically above 10°C).

  2. Enter calibration mode

    Press and hold a combination of the upshift and downshift buttons while starting the engine. The gear display should show 'CAL' or the oil temperature to confirm entry.

  3. Set engine RPM

    Set the engine speed to a specified RPM, often around 1200 RPM.

  4. Position the shuttle lever

    Move the shuttle lever to the FORWARD position.

  5. Calibrate clutches and synchronizers

    Cycle through the clutches (A, B, C, etc.) and synchronizers. This may be an automatic process or require pressing the upshift/downshift buttons. The two range potentiometers are often automatically calibrated during this process.

  6. Confirm successful calibration

    A 'CF' or similar message on the display indicates that the calibration has been completed and stored successfully.

  7. Store and exit

    Turn the key off to store the new calibration values.

  8. Pressure test hydraulic circuits

    If calibration fails or the 2407 code returns immediately, pressure test the synchronizer's hydraulic circuit to check for internal leaks.

  9. Replace suspect components

    If a mechanical or electrical failure is confirmed, replace the faulty range shift solenoid, synchronizer position sensor (potentiometer), or the synchronizer assembly.

Parts you might need

(3)
  • OEM part number. Aftermarket alternative: QTP-400665 (Fits T7000 and T7 Series with Power Command/Auto Command)

  • Alternative OEM part number: 87739558. Match connector colors (e.g., red, green, black) correctly.

  • Gear Position Potentiometer Sensor

    Ensure match to specific application (e.g., 'blocked hole' design for gear position monitoring).

Get help to fix this fault by requesting a quote

Browse other New Holland codes