New Holland 2414 – TCU: Operator Selected Lock Range
Issue description
The transmission control unit (TCU) has detected an attempt by the operator to shift into a gear range that the system has determined to be invalid or unavailable at that moment. This is a protective measure to prevent transmission damage and may prevent the machine from operating in the intended gear. This fault is typically a secondary code, appearing in conjunction with a primary fault code related to a component failure (such as a solenoid or range synchronizer sensor) that caused the controller to disable the range.
Applies to these machines
22 machines- T6.145
- T6.160
- T6.180
- T7.170
- T7.185
- T7.200
- T7.210
- T6030
- T6050
- T6070
- T6080
- T6090
- TM120
- TM130
- TM140
- TM155
- TM175
- TM190
- Workmaster 25
- Workmaster 35
- Workmaster 50
- Workmaster 75
Check the cause
Verify if the operator intentionally engaged the transmission range lock feature
Repair steps
Deactivate range lock
If the lock range is no longer desired, deactivate the mode through the tractor's transmission controls. This typically involves pressing and holding the 'auto' button or adjusting the options menu on the tractor's display to deselect the range lock feature.
Parts you might need
(5)Fits many T5, T6, T7, T8, T9 series and Case IH equivalents
Range Position Sensor/Potentiometer (Remanufactured)
47512672RFits various T7 models
Fits T7 tractors among other models
- Sensor47766973
Generic sensor listing
Replaces 84385112, 87312113, 47128280; fits T6, T7, T6000, T7000 series and Case IH equivalents
Get help to fix this fault by requesting a quote