New Holland 2425 – CCU: Disable Range Selected
Issue description
The transmission control unit has detected an attempt to shift into a range that is not permitted under the current operating conditions, or there is a fault within the range selection circuit preventing proper gear engagement. This system disablement prevents the machine from operating in the selected gear or mode. In some instances, the machine may move a few feet and then unexpectedly shift into neutral.
Applies to these machines
18 machines- T4.110F
- T7.170
- T7.175
- T7.185
- T7.190
- T7.210
- 5640
- 6640
- 7740
- 7840
- 8240
- 8340
- TS90
- TS100
- TS110
- TS115
- TM115-TM165
- T6000 Series
Check the cause
Verify operator procedure to ensure a valid range is being selected for the current tractor speed and status
Check for other active fault codes (such as 2421) which may point to a specific circuit failure
Visually inspect the wiring harness leading to the range selector switches on the transmission for stretched, pinched, or frayed wires, especially near zip ties
Test the shifter switches by swapping the electrical connectors between the two range selector switches to see if the fault code changes
Repair steps
Prepare machine for service
Park the tractor on level ground, engage the parking brake, chock the wheels, and disconnect the battery to prevent electrical shorts.
Locate and access range selector switches
Locate the range selector switches on the side of the transmission housing. Remove any necessary panels to access the switches and their connectors (e.g., one gray and one green connector).
Perform diagnostic switch swap
Disconnect the electrical connectors from the two range selector switches. Swap the connections (gray harness to green switch, and vice-versa). Reconnect the battery, turn the key on, and check if the fault code changes (e.g., to 2421). A change confirms a failed switch.
Replace faulty switch
Disconnect the battery again. Use a 19mm or 3/4-inch wrench to unscrew the failed switch from the transmission housing (expect a small amount of oil to leak). Crucially, transfer the sealing washer from the old switch to the new one, install, tighten securely, and reconnect the correct electrical harness.
Clear codes and test drive
Reconnect the battery, start the tractor, and use the diagnostic menu to clear all stored fault codes. Test drive the tractor by shifting through all ranges to verify the transmission operates correctly.
Parts you might need
(4)Also listed as 84195481-A. Verify fitment by serial number.
Transmission Range Selector Switch (Aftermarket)
QTP-400093Aftermarket switch for 40 and TS Series tractors.
Fits Case/New Holland Range Command Gearboxes (TM, T7, T6000 series).
Verify fitment by serial number.
Get help to fix this fault by requesting a quote