2425

New Holland 2425 – TCU: Range Disabled Selected

Issue description

The transmission control unit has disabled the selected gear range, preventing the machine from operating in the requested gear or mode. This safety-related restriction is typically triggered by a fault in the shifter mechanism, specifically the shifter range switches or their associated wiring, which fail to correctly signal the selected range to the transmission control unit.

Applies to these machines

  • T4 Series
  • T4.110F
  • T7 Series

Check the cause

  1. Verify the active fault code 2425 on the diagnostic display.

  2. Check for other active fault codes (such as 2421) that may point to a related switch issue.

  3. Inspect fuses related to the starter and transmission systems, as blown fuses can cause a concurrent no-start condition.

  4. Visually inspect the wiring harness leading to the shifter range switches for stretching, chafing, or damage from overly tight zip ties.

  5. Test the shifter range switches by disconnecting them one by one to see if the fault code clears, or use a power probe to test for proper voltage and ground.

Repair steps

  1. Ensure machine safety

    Park the tractor on level ground, engage the parking brake, and place all levers in neutral to prevent accidental movement.

  2. Access shifter switches

    Locate the shifter switches on the transmission housing, underneath the operator's cab.

  3. Repair wiring or replace switch

    If wiring is damaged, repair the harness. If a switch is identified as faulty, proceed to replacement.

  4. Replace faulty switch

    Disconnect the electrical connector. Use a 19mm or 3/4" wrench to unscrew the old switch from the transmission housing. Install and securely tighten the new switch, then reconnect the electrical connector.

  5. Clear codes and test

    Turn the ignition on and verify fault code 2425 has cleared. Start the tractor and test the shifter to ensure all ranges can be selected properly.

Parts you might need

(8)
  • Shifter Range Switch / Transmission Shift Rail Position Switch

    Generic part name. Confirm exact part number with dealer using serial number.

  • Sensor47766973

    Confirm exact part number with dealer using serial number.

  • For T & TG Series. Confirm exact part number with dealer using serial number.

  • Confirm exact part number with dealer using serial number.

  • Transmission Control Sensor Assembly

    73162489

    Confirm exact part number with dealer using serial number.

  • Shift Switch

    84134718

    Confirm exact part number with dealer using serial number.

  • Confirm exact part number with dealer using serial number.

  • Neutral Start Switch

    48001150

    Confirm exact part number with dealer using serial number.

Get help to fix this fault by requesting a quote

Browse other New Holland codes