2429

New Holland 2429 – XCM / TCM: Creeper Switch Always On

Issue description

The control module is receiving a persistent electrical signal from the creeper activation switch, indicating that the switch is stuck in the 'on' position or there is a short circuit in the wiring. The module interprets this as a continuous request to engage the creeper function, which can cause unintended operation of the creeper system and prevent normal transmission operation.

Applies to these machines

  • T5
  • T6
  • TS
  • G-Series
  • T6.155
  • TS6.110

Check the cause

  1. Visually examine the creeper switch for physical damage or signs of being mechanically stuck.

  2. Inspect the wiring harness connected to the switch for visible damage, such as chafing, cuts, or corrosion on the connectors.

  3. Access the on-board diagnostics 'H' menu and perform the H5 switch test routine to verify switch operation.

  4. Wiggle the wiring harness while the H5 test is active to check for intermittent connections.

  5. With the keyswitch OFF and battery/connectors disconnected, perform a continuity test on the signal wire to check for an open circuit.

  6. With the keyswitch OFF, perform a short to ground test by checking for continuity between the signal wire and chassis ground.

  7. With the keyswitch ON and harness disconnected from the switch, perform a short to power test by measuring DC voltage between the signal wire pin and chassis ground.

Repair steps

  1. Isolate the fault

    Determine if the fault lies with the switch or the wiring based on the H5 test. If the test shows the switch is always on and wiggling the harness has no effect, the switch is the likely cause. If wiggling the harness causes the display code to flicker, the problem is in the wiring.

  2. Replace the creeper switch

    If the switch is faulty, disconnect the negative battery terminal. Access the switch on the cab control console, disconnect the electrical connector, and remove the switch. Install the new switch, reconnect the electrical connector, and reassemble the console. Reconnect the battery and clear the fault code using the diagnostic tool or by following the manufacturer's procedure.

  3. Repair wiring harness

    If a wiring fault (open circuit or short) is found, locate the damaged section. Repair the wire using appropriate connectors and heat-shrink tubing, or replace the entire harness section if damage is extensive. Re-run continuity and short circuit tests to confirm the fix. Clear the fault code and verify normal operation.

Parts you might need

(4)

Get help to fix this fault by requesting a quote

Browse other New Holland codes