3004

New Holland 3004 – Engine ECU: Foot Throttle Sensor No Signal

Issue description

The Engine Control Module (ECM) has detected a complete loss of signal from the foot throttle sensor over the CAN bus network. This indicates that the ECM is no longer receiving the operator's desired throttle position, which can result from a faulty sensor, wiring harness issues, or a broader CAN bus communication breakdown.

Applies to these machines

  • W270B
  • T6010
  • T6020
  • T6030
  • T6040
  • T6050
  • T6060
  • T6070
  • T8 Series
  • C327
  • C338
  • T5060

Check the cause

  1. Check for 12V power supply at the designated power supply pin of the sensor connector (check associated fuse if voltage is absent)

  2. Verify a solid ground connection at the ground pin of the sensor connector

  3. Test for an approximate 5V reference signal supplied by the ECU at the reference pin on the sensor connector

  4. Back-probe the signal wire with a multimeter while slowly depressing the pedal; voltage should increase smoothly from approximately 0.55V at idle to 4.15V at full throttle without dropouts

  5. Measure CAN bus resistance between the CAN High and CAN Low wires with the machine powered off (should be approximately 60 Ohms to confirm terminating resistors are intact)

  6. Visually inspect the CAN bus wiring harness for chafing, corrosion, or loose connections, particularly around the throttle control and engine ECU

  7. Check that neither the CAN High nor CAN Low wire is shorted to ground or to a power source

Repair steps

  1. Perform Diagnostics

    Complete all the diagnostic checks listed above to isolate the root cause of the fault.

  2. Address wiring or connection issues

    If diagnostic checks reveal a lack of power, poor ground, or CAN bus communication errors, repair the wiring harness or connectors. This includes repairing breaks in wires, cleaning corroded pins, or securing loose connections.

  3. Replace throttle sensor or pedal assembly

    If the sensor fails the voltage sweep test (exhibits erratic readings, incorrect voltage output, or an internal open/short), replace the throttle position sensor or the entire accelerator pedal assembly.

  4. Clear fault codes

    After the repair is complete, use a diagnostic tool to clear the fault code from the engine ECU.

  5. Verify the repair

    Start the machine and operate the throttle to ensure that the engine responds correctly to throttle input and the fault code does not reappear.

Parts you might need

(3)
  • Throttle Control

    47409019

    OEM New Holland part, listed for Compact Track Loaders C327 and C338

  • OEM New Holland part

  • Throttle Control Linkage Components

    Various mechanical levers, cables, and supports available for models like the T5060; verify if the issue is mechanical vs. electronic

Get help to fix this fault by requesting a quote

Browse other New Holland codes